(1) You may not reproduce or transcribe any part of this publication without permission.
(2) We reserve the right to revise this document at any time without notice.
(3) If you have any questions about this document, contact your sales representative.
SAFETY NOTICE
(1) To prevent fire or electric shock, do not expose this appliance to rain or moisture.
(2) To avoid electric shock or damage to the eyes due to laser beam, do not attempt to
disassemble the cabinet.
For USA
(Model SW-9501-S only)
FEDERAL COMMUNICATIONS COMMISSION (FCC) RADIO
FREQUENCY INTERFERENCE STATEMENT
Class B Computing Device
NOTE : This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and , if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures :
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- - Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING : Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
CAUTION :
Use shielded connecting cables in order to meet FCC emission limits and also to prevent
interference to nearby radio and television reception.
iv
LASER SAFETY INFORMATION
Class 1 LASER Product
This equipment is certified to comply with DHHS Rule 21 CFR Chapter 1, Subchapter J in
effect as of date of manufacture.
Elsewhere, the drive is certified to conform to the requirements of the International
Electrotechnical Commission (IEC) 825 and CENELEC EN60825 for Class 1 laser
products.
Class 1 laser products are not considered to be hazardous. To ensure continued product
safety, the following precautions should be heeded.
Caution :
(1) The use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
(2) Do not open the drive unit; no user adjustments or serviceable parts are inside.
Laser radiation when open.
AVOID DIRECT EXPOSURE TO BEAM.
DANGER–
• This label is attached to the inner side of the rear wall on the Mechanism chassis
in the built-in drive unit.
CLASS 1 LASER PRODUCT
LASER KLASSE 1
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
APPAREIL A LASER DE CLASSE 1
EN60825
• This label is attached to the bottom of the drive enclosed box.
• Dieser Zettel befindet sich angeklebt am Boden des Außengehäuses von
Antriebsaggregat. (For German)
• Cette étiquette est appliquée sur le fond de la boîte extérieure de l’unité d’entraînement.
(For French)
• Denne etiketten är satt nederst på kassen til drive-apparatet. (For Swedish)
• Denne merkelappen er satt nederst på kassen til drive-aggregatet. (For Norwegian)
• Denne markeseddel er sat nederst på kassen til drive-aggregatet. (For Danish)
• Tämä tarra on kiinnitetty ohjainkotelon pohjaan. (For Finnish)
A-1
CAUTION –
LASER RADIATION WHEN OPEN
AVOID EXPOSURE TO BEAM
VORSICHT–
LASERSTRAHLUNG, WENN ABDECKUNG
..
GEOFFNET, NICHT DEM STRAHL AUSSETZEN
ADVARSEL–
º
LASERSTRALING VED ABNING.
ºº
UNDGA UDSÆTTELSE FOR STRALING
VARNING –
LASERSTRALNING NAR DENNA DEL
.. ..
AR OPPNAD. STRALEN AR FARLIG
DANGER –
Laser radiation when open.
AVOID DIRECT EXPOSURE TO BEAM.
º
..
º
..
º
ADVARSEL –
LASERSTRALING NAR DEKSEL APNES.
UNNGA EKSPONERING FOR STRALEN
VARO ! AVATTAESSA OLET
ALTTIINA LASERSATEILYLLE.
.. ....
ALA KATSO SATEESEEN
º
º
ºº
º
..
• This label is attached to the bottom of the built-in drive unit in the enclosed box.
• Dieser Zettel befindet sich angeklebt am Boden des eingebauten Antriebsaggregats im
Außengehäuse. (For German)
• Cette étiquetee est appliquée sur le fond de l’unité d’entraînement incorporée dans la boîte
extérieure. (For French)
• Denne etiketten är satt nederst på det innbyggd drive-apparatet i den omslutade boxen.
(For Swedish)
• Denne merkelappen er satt på bunnen av det innebygde drive-aggregatet i den lukkete
kassen. (For Norwegian)
• Denne markeseddel er sat på bunden af det indebyggede drive-aggregat i den lukkede
kasse. (For Danish)
• Tämä tarra on kiinnitetty kotelon sisässä olevan sisäänrakennetun ohjaimen pohjaan.
(For Finnish)
For Finnish
VAROITUS! Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla
saattaa altistaa käyttäjän turvallisuusluokan 1 ylittävälle näkymättömälle
lasersäteilylle.
For Swedish
VARNING! Om apparaten används på annat sätt än i denna bruksanvisning
specificerats, kan användaren utsättas för osynlig laserstrålning, som
överskrider gränsen för laserklass 1.