Panasonic 96NKX HNC850 Users Manual
Information and Troubleshooting Guide
Home Monitoring Camera Indoor
HomeHawk FLOOR
Model No.
-
KX-HN1053
What's included
microSD card
KX-HN1053 only
Connect the camera unit and
poles
Attach the poles to the
camera base
① Pass the power cord through the holes
in the camera base.
② Attach the poles to the camera base.
③ Wrap the power cord around the cord tie
and then connect the power jack.
④ Attach the camera base cover to the
camera base.
Pass the power cord through the poles
and connect the camera unit and poles
together.
Prepare the camera
① Confi rm the camera is located within the
range of your wireless router.
② Connect the AC adaptor from the camera
to a wall outlet.
• Wait about 1 minute until the camera’s
LED indicator stops blinking alternately
in yellow and green.
③ Insert a microSD card (not supplied) into
the camera’s microSD card slot.
Launch the HomeHawk app from your
smartphone by tapping the
icon.
Follow on-screen instructions.
Compatible device: iPhone®, iPad® (iOS 10.0
and later), AndroidTM 4.1 and later (As of
12/18).
AccessingtheUser'sGuide
The User’s Guide is a collection of online
documentation that helps you get the most
out of the [HomeHawk] app.
1 Tap in the app’s home screen.
2 Tap [Support].
3 Tap [User’s Guide].
GettingtheApp
Download the HomeHawk app for your
smartphone by either:
- Scanning the QR code
- Searching for "Panasonic HomeHawk" in the
app store
- Visiting
https://panasonic.net/cns/pcc/support/homeh
awk
Note:
• Android 4.1 or later versions are
recommended.
• You can also access the User’s Guide at the
web page listed below.
https://panasonic.net/cns/pcc/support/home
hawk/manual/
• Microsoft® Windows® Internet Explorer® 8
and earlier versions are not supported.
Part names and functions
Battery installation (for power
backup)
You can insert 8 AA (LR6) batteries (not
supplied) into the camera base to temporarily
power the camera in the event of a power
failure.
Please install the batteries before a power
failure occurs.
Important:
• Use only alkaline batteries.
• Do NOT use manganese Ni-Cd, Ni-MH
Lithium, or Lithium ion batteries
• Confirm correct polarities (+ , - ).
• Batteries are only intended for short-term use.
Once the batteries are installed, the AC
adaptor should be used as the power source
for the camera.
1 Open the camera base cover.
2 Install the batteries in the battery holder.
3 Close the camera cover.
Note:
• The HomeHawk app notifies you when the
battery power is low or when the battery
is out of power. In this case, remove and
replace all of the batteries with new ones.
Loading...