Fire alarm system
Rope elevator kit 6362
• A kit with all the necessary pieces for a rope elevator.
General
6362 is a kit to make a rope elevator for a
detector and its base, e.g. detector 3304 and
analog base 3312.
The kit
The kit consists of the following:
• Protective cover for detector (6360)
• Cleat (to fix the rope & hang it up;
not shown in the figure above)
• 20 m rope (Ø2 mm polyester)
• Metal plate
• Two screws (to fix the base)
• Two loop screws (for the rope)
• Two wood screws (to fix the cleat)
• Connection box (five screw term.)
• Cable clamp (for the conn. box)
• Rope clamp (to fix the rope)
• Cable clamp (to fix the cable)
Product applications
The rope elevator is used with any of the
Panasonic heat or smoke detectors plugged
in a base, allowing the user to access a
detector mounted on a high ceiling height, in
order to perform a test, maintenance, replace
the detector, etc.
Panasonic Electric Works Fire & Security Technology Europe AB
Citadellsvägen 23, SE-211 18 Malmö, Sweden
Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99
info@mfstech.com • www.panasonic-fire-security.com
Type number
6362 Rope elevator kit (Detector and base are not included.)
Mounting instructions
Loop screw for the rope
A
Base + Detector + Protective cover + mounting kit (see detail)
B
Flexible detector cable
C
Loop screw for the rope
D
Connection box and cable clamp
E
Cleat for the rope
F
D
E
A
B
C
i
e
h
Rope fixing point
1
Rope clamp (M10)
2
Flexible detector cable
3
Metal plate
4
Protective cover, bottom part
5
Cable clamp (M10)
6
Screw (to fix the base)
7
Base (for the detector)
8
c
d
f g
j
F
1.5 m.
≥
Connection instructions
L
C
L
C
Example showing how to connect the Analog base 3312.
2 m
≥
SA
SB
Base 3312
E+
E-
RKKR 4x0.5mm
Connection box
ELQYB 2x1mm
SA
SB
2
E+
E-
Technical data
Weight (g) ~500
All technical features and data are subject to changes without notice, resulting from continuous development and improvement.
Product Leaflet Date of issue Revision / Date of revision
MEW00316 2002-12-11 2 / 2006-08-31