Page 1
Improve Picture Quality with Home Theater
The Power Specialists Since 1975
®
Power Conditioners by Panamax
MAX® 5300-EX
THE SOURCE OF PURE SOUND AND PICTURE
™
TOP BENEFITS
1
Improves Picture and Sound Quality
Power Cleaning and Filtration eliminates common symp-
LEVEL 4
toms of contaminated power (including loss of detail, pops, hisses, hums and visual artifacts) and allows your A/V equipment to
perform up to its full capability.
Monitors Incoming Line Voltage and Provides a Visual
2
Indication of Power Level
Panamax’s patent pending AVM™ circuitry continuously monitors the incoming power displayed on the digital meter. A red
lightning bolt below the voltmeter will flash to indicate an under
or over voltage condition. Power to the connected equipment is
automatically turned off if either of these conditions is detected.
When voltage returns to a safe level, power to the equipment is
automatically reconnected.
3
Reduces Cross-Contamination Between Components
The M5300-EX is designed to provide noise isolation between 3
isolated outlet banks including 2 high current outlets so that any
noise created by an A/V component can not contaminate the
power going to equipment plugged into the other outlet banks.
FEATURES
LEVEL 4
Power Cleaning and
Filtration.
Protect or Disconnect™ Automatic
Voltage Monitoring Circuitry (AVM™)
Digital Voltmeter (incoming voltage) and Power Status Indicator
Lights
11 Outlets: 4 Always On,
4 Switched, 2 High Current,
1 Convenience (front)
3 Isolated Outlet Banks
Coaxial Signal Line Protection:
2 HD Sat and 2 HD CATV
Auto-resetting Telephone pay-perview and LAN Line Protection
DC Trigger input and output
Rack Mounting Brackets Included
Optional Silver Bezel
www.panamax.com
L549 REV A 5/05
Page 2
The Power Specialists Since 1975
®
MAX® 5300-EX REAR PANEL FEATURES
Circuit Breaker
Automatically opens
when the current load
is greater than 15
Amps.
Main Power
Must be plugged
into a properly
wired & grounded
3-wire outlet
Outlet Bank 3
Two switched, high current outlets controlled by the front
panel Power Button or the DC Trigger input. Bank 3 has a 5
second turn on delay and turns off immediately. The High
Current outlets provide power from a low impedance noise filtration circuit that does not limit the current to your equipment. Its output is noise isolated from all other outlet banks.
Ground Lug
Provides a common
grounding point for
equipment with separate ground leads.
Outlet Bank 2
Four switched outlets controlled by the front panel
Power Button or the DC Trigger input. Bank 2 will
turn on immediately and turn off after 10 seconds.
EMI/RFI noise filtration is provided by a three-stage
balanced Pi filter which also provides noise isolation
from Outlet Banks 1 and 3.
Outlet Bank 1
Four always on outlets. Power will only be turned
off under a fault condition. (See specifications for
over-voltage and under-voltage thresholds) Power
is cleaned by a three-stage balanced Pi filter which
also provides noise isolation from Outlet Banks 2
and 3.
MAX® 5300-EX SPECIFICATIONS
AC Power
Line Voltage:____________________________________________________120V, 60Hz
Total Current Capacity:__________________________________________________15 A
UL1449 Suppression Rating:____________________________________________330V
Protection Modes:______________________________________________L-N, L-G, N-G
Initial Clamping Level:_________________________________________________200V
Energy Dissipation:______________________________________________1815 Joules
Peak Impulse Current:___________________________________________73,000 Amps
Catastrophic Surge Circuit:_______________________________________________Yes
Thermal Fusing:_______________________________________________________Yes
Over-voltage shutoff:__________________________________________142 VAC ±5 VAC
Under-voltage shutoff:_________________________________________90 VAC ± 2 VAC
EMI/RFI Noise Filtration
Banks 1 - 4:_________________________________________ 90 db, 100 KHz – 2 MHz
Bank 3, High Current Outlets:____________________________60 db, 100 KHz – 2 MHz
Common Mode (all banks)____________________________ 60 db, 100 KHz - 2 MHz
DC Trigger Input
Jacks:_______________________________________________3.5mm (1/8”) mini-plug
Voltage and Polarity:___________________________________3 - 24V DC, bidirectional
Current Requirement:_________________________________4.6 mA @3V, 58 mA @24V
LAN Circuit
Clamping Level:____________________________________________________8V ± 2V
Jacks:_____________________________________________________________RJ-45
Wires Protected:_______________________________________4-Wires, Pins 1, 2, 3 & 6
Specifications subject to change due to product upgrades and improvements.
Satellite TV Coax Jacks
Bidirectional protection circuit optimized
for satellite TV signal lines.
Voltage Sense
Trigger Input
3.5mm (1/8”) Mini-Plug
jack. Connect to a remote
trigger device that uses a
DC output to trigger a startup/shutdown sequence.
This bypasses the front
panel power switch.
LAN Jacks
Protection circuits
for 10/100 baseT
Ethernet lines.
Cable TV Coax Jacks
Bidirectional protection circuit optimized for cable TV, off-air antennas
and cable modem signal lines.
Phone Jacks
Protection circuits for standard
telephone or pay-per-view lines.
Phone circuit is auto-resetting.
Telephone Circuit (pay-per-view)
Fuseless/Auto-resetting:_________________________________________________Yes
Clamping Level:______________________________________________________260V
Capacitance:__________________________________________________30pf (approx.)
Suppression Modes:____________________________________Metallic & Longitudinal
Jacks:_____________________________________________________________RJ-11
Wires Protected:___________________________________________2-Wire, Pins 4 & 5
DSL Compatible_______________________________________________________Yes
HD Satellite TV Circuit
Bidirectional:__________________________________________________________Yes
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________27V
Attenuation:______________________________________< 1db from 950MHz-2.05GHz
< 2.4db @ 2.2GHz
Connections:__________________________________________Female “F”, Gold Plated
HD Cable TV Circuit
Bidirectional:__________________________________________________________Yes
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________1.4V
Attenuation:________________________________________< 1db from 5MHz- 950MHz
Connections:__________________________________________Female “F”, Gold Plated
Pay-Per-View Compatible________________________________________________Yes
UPC’s, QUANTITIES, WEIGHTS & MEASUREMENTS FOR ORDERING & SHIPPING
MODEL M5300-EX UNIT CARTON MASTER CARTON
Dimensions Weight Dimensions Weight UPC Qty Dimensions Weight UPC
17" x 12.75" x 3.5" 17 lbs 23.75" x 19.25" x 9.5" 20.5 Lbs 0 50616 00786 3 1 Same as 20.5 Lbs 5 00 50616 00786 8
4.1" H with feet Unit Carton
OPTIONAL SILVER BEZEL
SILVER BEZEL PRODUCT UNIT CARTON MASTER CARTON
Model # Dimensions Weight Dimensions Weight UPC Qty Dimensions Weight UPC
BEZ5300-EXS 17" W x 0.625" D x 3.5" H 14.5 Oz 18" x 4" x 1" 18.5 Oz 0 50616 00792 4 N/A N/A N/A N/A
1690 Corporate Circle, Petaluma, CA 94954 • 800-472-5555 or 707-283-5900 • Fax - 707-283-5901 • www.panamax.com
© 2005 Panamax. Panamax, MAX and the Panamax logo are registered US trademarks of Panamax. Protect or Disconnect and AVM are trademarks of Panamax. SIDACtor is a registered US trademark of Teccor Electronics, Inc.
Loading...