Panamax M5500-EX, MAX 5500-EX ACRegenerator Specifications

Page 1
Improve Picture Quality with Home Theater
The Power Specialists Since 1975
®
Power Conditioners by Panamax
MAX® 5500-EX
ACRegenerator
THE SOURCE OF PURE SOUND AND PICTURE
TOP BENEFITS
1
Improves Picture and Sound Quality
Power Cleaning and Filtration eliminates common symptoms
LEVEL 6
of contaminated power (including loss of detail, pops, hisses, hums and
artifacts) and allows your A/V equipment to perform up to its full
visual capability. AC Regeneration feeds pure clean power to 4 isolated
outlets for video displays and source components.
2
Monitors Incoming Line Voltage and Provides a Visual Indication of Power Level
Panamax’s patent pending AVM™ circuitry continuously monitors the incoming power and amperage draw of connected equipment as dis­played on the digital meters. A red lightning bolt below the voltmeter will flash to indicate an under or over voltage condition. Power to the con­nected equipment is automatically turned off if either of these conditions is detected. When voltage returns to a safe level, power to the equipment is automatically reconnected.
FEATURES
LEVEL 6
Filtration with AC Regeneration (True Isolation Transformer Technology) with 4 amp capacity.
Protect or Disconnect™ Automatic Voltage Monitoring Circuitry (AVM™)
Digital Voltmeter (incoming volt­age) and Ammeter (total current draw) and Power Status Indicator Lights
11 Outlets: 4 Always On, 4 Switched, 2 High Current, 1 Convenience (front)
Power Cleaning and
5 Isolated Outlet Banks
Coaxial Signal Line Protection: 2 HD Sat and 2 HD CATV
Auto-resetting Telephone (pay­per-view) and LAN Line Protection
DC Trigger input and output
Rack Mounting Brackets Included
Optional Silver Bezel
3
Reduces Cross-Contamination Between Components
The M5500-EX is designed to provide noise isolation between 5 isolated outlet banks including 2 high current outlets so that any noise created by an A/V component cannot contaminate the power going to equipment plugged into the other outlet banks.
www.panamax.com
L551 REV A 5/05
Page 2
MAX® 5500-EX REAR PANEL FEATURES
The Power Specialists Since 1975
®
Main Circuit Breaker
Automatically opens when the current load is greater than 15 Amps.
Main Power
Must be plugged into a properly wired & grounded 3-wire outlet
Ground Lug
Provides a common grounding point for equipment with separate ground leads.
Outlet Banks 3 & 4
Two switched outlets per bank. ON/OFF status is controlled by the
front panel Power Button or the DC Trigger input. They will turn on immediately and turn off after 10 seconds. EMI/RFI noise filtration is provided by the Isolation Transformer in conjunction with a three­stage balanced Pi filter. Banks 3 and 4 are noise isolated from each other as well as all other outlet banks
Outlet Bank 5
Two switched, high current outlets controlled by
the front panel Power Button or the DC Trigger input. Bank 5 has a 5 second turn on delay and turns off immediately. The High Current outlets provide power from a low impedance noise filtra­tion circuit that does not limit the current to your equipment. Its output is noise isolated from all of the other outlet banks.
.
Outlet Banks 1 & 2
Two always on outlets per bank. Power will only be
turned off under a fault condition. (See specifications for over-voltage and under-voltage thresholds) Power for each bank is cleaned by a four-stage bal­anced Pi filter. Banks 1 and 2 are noise isolated from each other as well as all other outlet banks.
Voltage Sense Trigger Input
3.5mm (1/8”) Mini-Plug jack. Connect to a remote trigger device that uses a DC output to trigger a startup/shutdown sequence. This bypasses the front panel power switch.
MAX® 5500-EX SPECIFICATIONS
AC Power
Line Voltage:____________________________________________________120V, 60Hz Total Current Capacity:__________________________________________________15 A UL1449 Suppression Rating:____________________________________________330V Protection Modes:______________________________________________L-N, L-G, N-G Initial Clamping Level:_________________________________________________200V Energy Dissipation:______________________________________________1815 Joules Peak Impulse Current:___________________________________________73,000 Amps Catastrophic Surge Circuit:_______________________________________________Yes Thermal Fusing:_______________________________________________________Yes Over-voltage shutoff:__________________________________________142 VAC ±5 VAC Under-voltage shutoff:_________________________________________90 VAC ± 2 VAC EMI/RFI Noise Filtration
Banks 1 - 4:________________________________________100 db, 100 KHz – 2 MHz Bank 5, High Current Outlets:____________________________60 db, 100 KHz – 2 MHz Common Mode (banks 3 & 4, Isolation Transformer)_________120 db, 100 KHz - 2 MHz
DC Trigger Input
Jacks:_______________________________________________3.5mm (1/8”) mini-plug Voltage and Polarity:___________________________________3 - 24V DC, bidirectional Current Requirement:_________________________________4.6 mA @3V, 58 mA @24V
DC Trigger Output
Voltage:____________________________________________________________<15V Current:_________________________________________________________<500 mA Short-circuit protection:_________________________________________________Yes Delay on output:_________________________________________________10 seconds
(banks 1, 2 & 5__________________________60 db, 100 KHz - 2 MHz
Isolation Transformer Circuit Breaker
Automatically opens when the combined current load for Outlet Banks 3 and 4 is greater than 4 Amps.
Voltage Sense Trigger Output
3.5mm (1/8”) Mini-Plug jack. Connecting a trigger wire to the Voltage Sense Output jack will allow the input signal to pass through the MAX® 5500-EX to control the startup/shutdown of an additional device.
High Current Outlets Delay Switch For Outlet Bank 5
Allows the outlet bank to be set as “Always ON” or with a 5 second turn-on delay
Isolation Transformer Outlets Delay Switch For Outlet Banks 3 & 4
Allows the outlet banks to be set as “Always ON” or with a 10 second turn-off delay
Satellite TV Coax Jacks
Bidirectional protection circuit optimized for satellite TV signal lines.
LAN Jacks
Protection circuits for 10/100 baseT Ethernet lines.
Cable TV Coax Jacks
Bidirectional protection circuit opti­mized for cable TV, off-air antennas and cable modem signal lines.
Phone Jacks
Protection circuits for stan­dard telephone or pay-per­view lines. Phone circuit is auto-resetting.
LAN Circuit
Clamping Level:____________________________________________________8V ± 2V Jacks:_____________________________________________________________RJ-45 Wires Protected:_______________________________________4-Wires, Pins 1, 2, 3 & 6
Telephone Circuit
Fuseless/Auto-resetting:_________________________________________________Yes Clamping Level:______________________________________________________260V Capacitance:__________________________________________________30pf (approx.) Suppression Modes:____________________________________Metallic & Longitudinal Jacks:_____________________________________________________________RJ-11 Wires Protected:___________________________________________2-Wire, Pins 4 & 5
Satellite TV Circuit
Bidirectional:__________________________________________________________Yes Shielded:_____________________________________________________________Yes Clamping Level:_______________________________________________________27V Attenuation:______________________________________< 1db from 950MHz-2.05GHz
< 2.4db @ 2.2GHz
Connections:__________________________________________Female “F”, Gold Plated
Cable TV Circuit
Bidirectional:__________________________________________________________Yes Shielded:_____________________________________________________________Yes Clamping Level:_______________________________________________________1.4V Attenuation:________________________________________< 1db from 5MHz- 950MHz Connections:__________________________________________Female “F”, Gold Plated
UPC’s, QUANTITIES, WEIGHTS & MEASUREMENTS FOR ORDERING & SHIPPING
MODEL M5500-EX UNIT CARTON MASTER CARTON
Dimensions Weight Dimensions Weight UPC Qty Dimensions Weight UPC
17" x 12.75" x 3.5" 28 lbs 23.75" x 19.25" x 9.5" 31.5 Lbs 0 50616 00788 7 1 Same as 31.5 Lbs 5 00 50616 00788 2
4.1" H with feet Unit Carton
OPTIONAL SILVER BEZEL
SILVER BEZEL PRODUCT UNIT CARTON MASTER CARTON
Model # Dimensions Weight Dimensions Weight UPC Qty Dimensions Weight UPC
BEZ5500-EXS 17" W x 0.625" D x 3.5" H 14.5 Oz 18" x 4" x 1" 18.0 Oz 0 50616 00794 8 N/A N/A N/A N/A
1690 Corporate Circle, Petaluma, CA 94954 800-472-5555 or 707-283-5900 Fax - 707-283-5901 www.panamax.com
© 2005 Panamax. Panamax, MAX and the Panamax logo are registered US trademarks of Panamax. Protect or Disconnect and AVM are trademarks of Panamax. SIDACtor is a registered US trademark of Teccor Electronics, Inc.
Specifications subject to change due to product upgrades and improvements.
Loading...