Pamex E7000/AK Installation Manual
10212 ZINS-R7028-00
Features
Alarm kit contains an internal horn and LED light, when the
pushbar is depressed, the LED light will blink and horn will siren
to provide a visible/audible means of signaling that the opening
2. Place the 9V Battery onto the panel.
ON
has been violated.
The alarm kit can be armed or disarmed by key.
The horn is rated at 95 decibel.
The key switch uses a standard 1 1/4" cylinder with S keyway.
The unit operates on one standard 9-volt alkaline battery.
Device includes
"EMERGENCY EXIT ONLY. ALARM WILL SOUND"
decal for application on door or pushbar.
Installtion Instruction
1. Assemble the alarm kit with parts shown below :
Switch to Alarm
Cam should be in OFF position before battery is installed.
3. Alarm siren time may be adjust to 1,3,5,and infinite minutes.
To adjust the alarm time, See Figure 1.
4. Remove the end cap and bracket.
5. Slide the cover out.
6. Insert alarm kit.
Alarm
time
Figure
＊Figure 1
1 Min. 3 Min. 5 Min. infinite
ON
1 2
ON
1 2
ON
1 2
ON
1 2
7. Re-install the end cap and bracket.
Operating Instructions
1. Insert the key into the cylinder and turn counterclockwise to arm the
unit.
2. The siren will sound three short beeps indicating the unit is armed.
3. Depress the pushbar, the alarm should sound immediately and
Battery
Battery seat
Alarm time
switch
Threaded
Fastening ring
On/off
control cam
Cylinder
Arm/Disarm
Switch
red/green LED light will blink.
4. Turn the key clockwise to disarm.
Note
1. If alarm siren time is set to infinite minutes, alarm will sound until
battery runs out.
2. Siren will beep and red LED will blink at approximately 6 seconds
intervals when battery is low.
Installtion Instruction Alarming Device
1. Assemble the alarm kit with
parts shown below.
Switch to Alarm
Battery seat
Alarm time
switch
Arm/Disarm
Switch
Battery
On/off
control cam
Threaded
Fastening ring
Cylinder
2. Place the 9V Battery into the
panel.
ON
3. To adjust the alarm time, kindly
set the 2pin dip switch as
shown below：
Alarm time
1 Min.
3 Min.
5 Min.
Infinite
Factory preset
Figure
ON
1 2
ON
1 2
ON
1 2
ON
1 2
Alarm time switch
Alarm time switch
ON
4. Remove the end cap and
bracket.
5. Slide the cover out.
Cam should be in OFF position
before battery is installed.
6. Insert alarm kit.
7. Re-install the end cap and
bracket.
LED
Siren
Cylinder
End cap
Loading...