Palsonic PCR17BT User Manual

PCR17BT

USER MANUAL

E-2

CAU TION

DO NO T EXPOSE TO D RIPPING

OR SP LASHING LIQ UIDS!

NOTE: CAUTION SYMBOLS ARE PRINTED O N BOTTOM OF UNIT.
PLEASE REFER TO INSTRUCTION MANUAL.

CAUT ION:

INVIS IBLE LASER RADIATI ON WHEN OPEN AN D INTERL OCKS D EFEATED. AV OID EXPO SURE TO B EAM.

VORSIC HT:

UNSIC HTBARE LASE RSTRAHL UNG TRI TT AUS, WENN DE CKEL G EÖFFNET U ND WENN SICHERHEIT SVERRIEGEL UNG

ÜBERB RÜCKT IST. NICHT D EM STRA HL AU SSETZENI.

VARNING :

OSYNLI G LAS ERSTRÁL NING NÄ R DENNA DEL Ä R ÖPPNA D OCH SPÄRR Ä R URK OPPLAN D. STRÁ LEN Ä R FARLI G.

ADVAR SEL: USYNLIG L ASERST RÁLING VED Á BNING. NÁR SIK KERHED SAFBRYD ERE ER U DE AF FUNKTION . UNDGÁ

UDS/ETT ELSE FO R STRÁL ING.

ATTNENZ IONE: RA DIONS L ASER INVISIDIL E. NON GUARDA RE DIRETTA MENTE NE LLA S ORGENTE D EL LA SER.
ACHT UNG: L ASERLI NSE NICHT BERÜH REN UNSIC HTBARE R LAS ERSTRAHL .
AVISO: A LEN TE NUNCA DEVE SE R TOCADA .

PLE ASE NOTE: YOU WILL FIN D THE
RATI NG LAB EL FO R THIS P RODUC T
LOCATED O N THE BOTTOM O F THE UNIT.

CAU TION: GROUNDING OR POL ARIZATIO N. THE P RECAUTIONS S HOULD BE TAKEN
SO THAT THE W IDER B LADE OF THE AC PLUG MUST MATCH THE SLOT IN
RECEP TACLE "WALL SOCKET".

WARNI NG:
TO RED UCE TH E RISK OF F IRE O R ELECTRIC SHOCK, DO N OT EXP OSE TH IS
APPLI ANCE TO DRIPPING OR SPLASHING LIQ UIDS.

THE AC/D C ADAPTOR IS USED AS THE DISCONNECT DEVIC E AND IT SHA LL REMA IN
READILY OPERAB LE. TO COMPLETELY DIS CONNECT TH E POWER INP UT, THE
AC/DC A DAPTOR OF THE APPARATUS MUST B E DISCONNEC TED FROM THE MAIN S
COMPLE TELY. THE AC/DC ADAPTOR SHOU LD NOT BE OBSTRUC TED O R SHOULD BE
EASILY ACCESSED DURING INTENDED USE.

The lightning flash and arrowhead within the triangle is a warning sign
alerting you of "dangerous voltage" inside the product.

CA UTION

RISK OF E LECTRIC S HOCK

DO NOT OPEN

WARNING:
To reduce the risk of e lectric shock, do not remove c over (or back). No
user-serviceable parts inside. R efer servicing to qualified service p ersonnel.

CAUTION:
The exclamation point within the triangle is a warning sign alerting you of
important instructions accompanying the product.

THE APPARATUS SHOULD NOT BE EXP OSED TO DRIPPIN G OR SPLASHING AND NO OBJE CTS
FILLE D WITH LIQUIDS SHOU LD BE PLA CED ON THE AP PARATUS.

UNDER THE I NFLUENCE OF ELE CTROSTATIC PHENOMENON,
THE PRODUC T MAY MALF UNCTION AND USER TO POWER RESE T.

THE MARK ING AND RATING LABE L I S LOCATED AT BOTT OM ENCLOSURE OF THE APPARATUS.

- KEEP MINIMUM DISTAN CES (5cm ) AROUND THE APPAR ATUS O F SUFFICIEN T
VEN TILATION.

- NO NAK ED FLA ME SOURCE S, SU CH AS LIGHTED CANDL ES, SHOUL D BE PL ACE D
ON THE A PPARATU S.

- THE USE OF APPARATUS IN M ODERAT E CL IMATES.

Elegant Alarm Clock Radio

E-4

E-3

AC OPERATION (EXTERNAL AC-DC POWER ADAPTOR)

- THIS SET IS EQUIP PED WI TH A "DC-J ACK" C APABLE OF ACCEPT ING
AC-ADAPTORS WITH A RATING OF DC = 5V, 2A, AN D WITH A PLUG
WITH THE FOLLOWI NG POLARITI ES AS SHOWN (C ENTER POSIT IVE) :

- PLEASE USE ONLY THE SUPPLIED AC-ADAPTOR TO OPERATE THE
UNIT. USE OF OTHER ADAPTORS MAY DAMAGE THE UNIT OR CAUSE
IT TO MALFUN CTION .

- PLUG THE TAIL END OF THE AC-ADAPTOR I NTO THE DC-JACK (S OCKET )
ON TH E REAR OF THE UNIT.

- INSERT THE P LUG OF THE AC-ADAPTOR INTO A WALL O UTLET WITH AC-POWER.

- PRESS THE "ON/ OFF" KE Y TO SWITCH ON THE UNIT.

- THIS UNIT IS DESI GNED TO OPERATE WITHOUT EVER BEING TOTALLY POWE RED
"OFF". IT WILL EITHER BE "ON" OR IN "STANDBY MODE".

- IN S TANDBY MODE, THE BACK-LIGHT OF THE DIGITAL DISPLAY WILL BE DIMMED
BUT THE DISPLAY WILL S HOW THE CURRENT TIME (CLOCK FUN CTION).

- ANYTIME DURING STAND BY MODE, YOU CAN SW ITCH "ON" TH E UNIT BY PRESSING
THE " ON/ OFF" KEY.

- SAVE EN ERGY BY SWITCHING T HE SYS TEM TO "STANDBY" MODE WHEN NOT IN USE.

POWER SUPPLY

-

+

DIMMER FUNCTION

THIS SET HAS A DI MMER F UNCTI ON TO ADJUST THE BRIGHTNESS LEVEL
OF THE DISPL AY BACKLIGHT. SIMPLY ADJU ST IT AS D ESIRE D BY PR ESSING
THE SNOOZE/ DIMMER KEY REPEATED LY (HI-BR IGHTNESS / LOW-BRIGHTNE SS / O FF)
THE DISPLAY BACKLIGH T WILL ALWAYS RETURN TO H I-BRIGHTNESS AS THE DEFAULT,
AFTER THE UN IT BEEN RESET.

DIGITAL CLOCK FUNCTION

- THE S ET HAS A BU ILT-IN DIGITAL CLOCK.
(THE DISPLAY WILL CONTINUOUSLY SHOW THE CURRENT TIME).

HOW TO SET CORRECT TIME:

SWITCH UNIT TO "STAND-BY" MODE

PRESS & HOLD CLK SET KEY FOR 3 SECOND S DISPLAY SHOWS
HOUR OR HOUR (FLASHI NG)

12H

24H

PRESS BACK OR NEXT KEY TO SEL ECT 12-HOUR OR
24-HOUR CLOCK DI SPLAY SYSTEM & PRESS CLK SET

KEY T O CONFIRM YOUR

SELECTI ON.

PRESS REPEATEDLY TO SET
THE CORREC T HOUR IN THE DISPLAY & PRES S TO CONFI RM.

BACK OR NEXT KEY

CLK SET KEY

CORREC T TIME IS NOW SET & WIL L BE SHOWN IN THE DISPLAY.

PRESS REPEATEDLY TO SET
THE CORREC T MINUTE IN THE DISPLAY & PRESS TO CONFI RM.

BACK OR NEXT KEY

CLK SET KEY

1.

2.

3.

4.

5.

6.

1. Device rear support stand

2. Slot for placing your Device
(Smartphone / Tablet)

3. LED Display

4. Back key

5. Next key

6. Memory key

7. On/ Off key

8. Vol - / AL. Mode key

9. Vol+ / CLK Set key

10. Function key

11. Play/ Pair key

12. Snooze/ Dimmer key

13. USB output charger port

14. Aux-Input socket

15. DC Input socket (DC 5V )

16. Headphones socket

17. FM antenna wire

LOCATION OF CONTROLS

FRONT VIEW:

BACK VIEW:

1

TOP VIEW:

17

3

2

12

4

5

6 7

8 9 10

11

16

15

14

13

- - -

OPERATION

ALARM FUNCTION

- THIS SET IS EQUIPPED WITH 2 ALAR M MOD ES: BUZZER RADIO .
BEF ORE SETTING THE ALARM, M AKE SURE TO SET THE CLOCK (SE E "DIGITAL
CLO CK FUNCTION" IN THE PR EVIOUS SECTION) .

AND

PREPARE FOR THE AL ARM SETTINGS

1

2. PR ESS AND HOLD AL . MODE KEY UNTIL
THE DISPL AY WILL NO W SHOW:

3. PR ESS BACK KE Y OR NEXT KEY TO RE ACH TH E HOU R
OF T HE DE SIRED WAKE UP TIME THEN PRESS AL. MODE KEY TO CO NFIRM.
THE DISPL AY WILL NO W SHOW:

. PRE SS THE ON/OFF KE Y TO PUT THE S ET INTO "STANDBY" MODE

00 00

HO UR (F LA SH IN G)

MI NU TES
(F LA SH ING )

8 00

A. " ALA RM" SETTING