Palsonic PAL50BFZ, PAL112BFZ User Manual

PAL50BFZ
PAL112BFZ

50 /112 Litre Bar Refrigerator

Offering Australians quality since 1958 | www.palsonic.com.au

User’s Manual

General

This type of refrigerator is widely used in places
such as hotels, offices, student dormitories and
houses. It is mostly suitable for refrigerating and
preserving foods such as fruits and beverage. It
enjoys the advantages of small size, Lightweight,
low elect ric consumption and easy use.

Instructions for Installation

1. Do not tilt the refrigerator for more than 45

0

from upright during moving it. Do not apply
force on any part such as condenser or door to
prevent the refrigerator from deforming, or else
it will influence its performance.

2. Let the refrigerator have enough space to work
well.

3. Don’t install it in an area of high temperature or
humidity. This is to avoid it being damaged,
dampened and rus ted.

Cautions for Safety

1. Before the refrigerator is plugged in, please
check and make sure the v

oltage is 240volt
the same as the rated voltage. Use the
independent socket, of the power plug.
An adapter may cause the socket to overheat.

2. D on’t store inflammable materials such as ether,

1

p

etrol, LP gas and glue etc in the refrigerator.

3. Don’t splash water on the refrigerator; it may
cause malfunction or electric shock.

4. If gas leaks from its container. Do not pull the
plug out or in as it may arose sparks and fire
calamities.

Instructions for Use

1.

When operating the refrigerator for the first time,
run it without load

ing any food until its auto
tops at the desired temperature. Usually it takes
2 or 3hours, then set the thermostatic dial at the
setting desired and then load the refrigerator.

2. The temperature of the refrigerator can be
adjusted by turning the thermostatic dial. A
medium setting of the thermostatic dial is the
most suitable for genera l operation.

3. Defrost the freezing compartment whenever the
layer of frost on the surface of the evaporator
reaches 3 or 4 mm. When defrosting, remove all
food and set the thermostat at “OFF” position.
Put the drip tray under the evaporator to collect
melted water. After the frost has melted, discard
the melted water and dry up the interior of
refrigerator. The refrigerator can then be
restarted by turning its th ermostat to the desired
setting.

2