Palsonic DVD3000 EASY GUIDE

DIGITAL VIDEO

DIGITAL VIDEO DISC PLAYER

MODEL: DVD3000

DVD / VIDEO CD / AUDIO CD PLAYER

EASY GUIDE

DIGITAL AUDIO

DIGITAL

PALSONIC CUSTOMER SERVICE

TELEPHONE

AUSTRALIA: 1300 657 888

PALSONIC CORPORATION PTY LTD

1 JOYNTON AVE

WATERLOO NSW 2017 AUSTRALIA

TEL:[phone]

FAX:[phone]

l

Basic connection

Set the power switches on the player and equipment to be connected to OFF beforeconnecting.

l

l Read through the instruction for the equipment to be connected.
l Be sure that the colors of the connectors and plugs match up when connecting the cord.

Connecting to a TV with stereo sound

1. TV set (optional)

2. DVD player

3. Audio/Video cord (supplied)

4. S-video cord (optional)

5. To audio input connectors (red, white)

6. To video input connector (yellow)

7. To S-video input connector*

A B

Connecting to an audio equipment

1. Audio equipment (optional)

2. TV set (optional)

3. DVD player

4. Audio cord (optional)

5. To audio input connectors (red, white).

6. Video cord (optional)

7. S-video cord (optional)

8. Power cord to power outlet (AC 110-240V, 50/60 Hz)

(See

mentioned above)

A

Note:

When the above connection is made, you must change “CNTR and REAR SPEARER” , “SUBWOOFER”

setting to “OFF”. (refer to page 21)

Notes:

l During DVD playing, the TV volume may be at a lower level than during TV broadcast. If this is the case,

adjust the volume to the desired level.

If the DVD player is connected to the TV through a video cassette recorder, the picture may not be played

back normally with some DVD discs. If this is the case, do not connect the player via the VCR.

*The S(separate) video output connector separates the chrominance (C) and luminance (Y) signals before

transmitting them to the TV set in order to achieve a sharper picture.

Use the S-video cord (optional) when connecting the player to a TV set equipped with an S-video input

connector for the best picture clarity possible.

Caution for connection of digital audio output terminal:

On “DIGIT AL AUDIO OUT” terminal, don’t connect amplify without Dolby AC-3 decoder. Otherwise, the
attempt to play DVD discs may cause a high level of noise that it may be harmful to your ears and damage
your speakers.

l

Optional audio connection

Connecting to an AC-3amplifier or an AC-3 decoder

1. TV set (optional)

2. DVD player

3.Audio/Video cord (supplied) S-video cord (optional)

4. AC-3 decoder

C

5. connect to RF input terminal of AC-3 decoder (optional)

6. direct connect to 5.1ch amplifier .

l

With connecting to 5 or 6 (optional one), When DVD

discsrecorded in Dolby Digital Surround are played, you

can enjoytheater-quality audio right in your home.