palintest DigiPAsS Operation Manual

Graduated
Flask
Take one Hydrogen Sulphide Removal Filter
and insert into the bottom end of the bung.
and open.
Take the DigiPAsS and press any key to switch on.
This will then say 'Insert Slide'.
Take the pre-loaded Black Arsenic Filter Slide
(the one that has just been tted with lter paper) and insert slide.
Then DigiPAsS will instruct to 'Remove Slide', once slide is removed this
then instructs to 'Run Test’, which automatically activates timer on the DigiPAsS.
Then take the Black Filter Slide and insert
into the bottom slot of the bung.
Take one Filter Paper from red labelled pot, use forceps and/or
gloves to insert into position. (repeat lter paper insertion as before)
Get Bung device and ONLY insert
the Red Filter (Removal) Slide into the top slot.
Take Black Arsenic Filter Slide and open.
Take one Filter Paper from black labelled pot, use
forceps and/or gloves to insert into position ensuring
the lter paper is evenly covering the hole.Then
rmly close slide holder, taking care to locate the pins
in the slide holder correctly.
Dilution Tube Cleaning
Brush
Colour Chart
Waste Disposal Bag,
Gloves & Forceps
Tri-Filter Arsenic Trap
(Bung)
Operation Equipment Key
Stage 1: Loading bung device
Stage 2: Calibrating the DigiPAsS
Hydrogen Sulphide
Removal Filters
Black Filter Slide
(Detection)
DigiPAsS
Red Filter Slide
(Removal)
Screwdriver
DigiPAsS Operation Manual
Filter Paper (arsenic test)
(Labelled Black)
Filter Paper (removal)
(Labelled Red)
Tablets A2
Powder Sachet
#
*
A 1
A2
#
*
*
#
#
*
#
*
Loading...