pagertec SMART STACK PAGING SYSTEM User Manual
Smart Stack Paging System
Thank you for choosing Pagertec
Thank you for choosing Pagertec as your provider for your wireless paging requirements.
We greatly appreciate your condence in our products. At Pagertec our greatest commitment
is providing you with total customer satisfaction. Please take a few minutes to review this
manual prior to installing and operating your system. The manual will provide you with
installation instructions, and offer suggestions to ensure you receive all of the many
benets your system can provide. Additionally, this manual will assist you with problem
determination and offer helpful advice when seeking customer service. We are condent
Pagertec has the most responsive customer service available within the industry. Please
do not hesitate to contact out Customer Care, if you have any questions. We look forward
to a long and mutually rewarding partnership.
2
Smart Stack
PAGING SYSTEM
3
Installing the Transmitter
The rst consideration in the placement of the transmitter is convenience. It should be
readily accessible in a central location within the paging area. Pay close attention to nearby
obstructions such as walls, pipes, ducts, mirrored glass, or other similar barriers that may
weaken or misdirect transmitted signals. Certain materials and construction, especially metal,
have the potential to partially or completely block the paging signal.
The next consideration involves safety. Ensure the unit is securely mounted and away
from liquids, extreme heat and possible physical damage. Also remember that the
transmitting unit requires a 110V AC power outlet. Be sure an antenna is attached prior
to applying power to avoid damage to the transmitter. An optional molded plastic cover is
available as an accessory purchase, to protect the transmitter, especially in areas where
spillage is possible.
For best results, the transmitter antenna must be vertical. Ideally the transmitter should
be centrally located within the area where paging is to occur. Since this is not always possible,
range testing at different locations may be required to obtain the desired performance.
Once the Desktop Transmitter and antenna have been installed, plug in the power adapter.
Once powered the transmitter will display “Enter Number’’ indicating it is ready to send
a page. We recommend some type of surge suppressor on the power supply for protection.
Power surges are not covered under system warranty.
4
Loading...