PAG 9775,VBPC-200 Users Guide

PAG Ltd.

565 Kingston Road
Raynes Park
London SW20 8SA

E [e-mail]
T [phone]
F [phone]
www.paguk.com

PAG VBPC-200

Vehicle Battery Power Converter 12V 200W

Model 9775

GENERAL INFORMATION

This small, lightweight, economic unit
converts the vehicle’s 12 volt battery output
to 300 volts DC, and is ideal for powering
equipment employing switch-mode power
conversion techniques.

The unit provides a powerful 200 watts
continuous output and allows short term use
up to 250 watts. This power is sufficient to
run RMC4X rack-mountable chargers, 12V AR
Series chargers and the integral chargers of
all Pagbelts.

The unit is fitted with a plug for direct
connection to the vehicle’s cigar lighter
socket. An amber LED indicates connection to
the vehicle battery. To turn the unit off,
simply disconnect it from the cigar lighter
socket. (The vehicle cigar lighter socket and
wiring harness must be capable of carrying a
minimum current of 20 amps).

The unit incorporates an audible warning
system which operates when the vehicle
battery needs to be boosted by starting the
vehicle’s engine. However, if the vehicle’s
engine is not started and the battery voltage
continues to fall, the unit will switch-off
(latch out), leaving enough power to start the
vehicle. Unplugging the unit will reset the
latch. Then, after boosting the vehicle
battery, reconnect the unit.

This unit is only suitable for use with veh­icles having the negative of the battery
connected to the chassis - ‘negative earth’.

SUITABILITY

The output of the unit is only suitable for
equipment employing switch-mode power
conversion, and is not to be used with
equipment that incorporates a primary
mains transformer.

DISREGARD OF THIS CAUTION COULD RESULT
IN DAMAGE TO CERTAIN EQUIPMENT TYPES.

Note that a simple test may be done to
determine the compatibility of equipment
to be used with the unit. Using a meter,
measure the resistance between the live and
negative pin of the equipment’s mains plug.
With its switch on a resistance reading of
greater than 10,000 ohms indicates that
the input circuit is suitable for use with the
Vehicle Battery-Power Converter, provided
that its load does not exceed 200 watts.
If in doubt consult your PAG Dealer or a
qualified electrical engineer.

CONNECTION

Plug the unit into the vehicle cigar lighter
socket, using the cable mounted plug.
Power is then available on the standard
IEC output lead.

Unplug the unit when not in use, other­wise it will continue to draw current, slowly
discharging the battery.

SPECIFICATION

Output: 300V DC, power available is 200
watts maximum, with 250W short term
capability.

In use the unit draws about 1 amp from the
battery for every 10 watts of actual load
applied.

SELF PROTECTION SYSTEM

If overloaded the unit will switch-off (latch­out), requiring momentary disconnection from
the vehicle battery/ cigar socket to reset.

SAFETY INFORMATION
WARNING: This unit produces a very high DC

voltage level. To ensure continued safety you
MUST adhere to the following instructions:

Never extend or tamper with the input or
output leads.

DO NOT OPEN THE UNIT TO INVESTIGATE
MALFUNCTION. Sufficient energy may remain

stored in the unit to cause SERIOUS INJURY
up to 30 minutes after it has been discon­nected from the vehicle battery. Lack of
output is not an indication of safety.

Connecting a load does not discharge the
internal circuits.

OPERATIONAL INFORMATION

It is advisable to run your vehicle engine
occasionally if an extended period of use
is required.

The unit incorporates an audible warning
system which operates when battery voltage
falls below 11 volts, with a safety low voltage
latch-out at 10 volts. This will leave enough
power in the battery to start the vehicle.

When positioning the unit ensure that there
is no tension on the input lead.

Do not cover the unit as it retains heat if
used at high power for an extended period.

Never leave the unit connected when not
in use. If you do it will continue to draw
current, slowly discharging the battery.

Never use with any appliance rated above
200W.

TAMPERING WITH THE UNIT WILL INVALI­DATE THE WARRANTY.

Always use with equipment satisfying inter­national safety standards. Treat the output
with the same caution as a 13A mains socket.

Consult your PAG Dealer or a qualified
electrical engineer if in doubt about any
proposed permanent installation.

CAUTION: THIS UNIT IS FOR IN-VEHICLE USE
ONLY. PROTECT FROM MOISTURE.

Every time you use the unit or any electrical
appliance, check that all connections and
screws etc. are tight, and that there is no
damage to wire insulation. Make sure that
cables do not chafe on sharp objects.

JULY 2012