Pacific Track PT30 Users manual

Pacific Track, LLC

1300 Bristol Street North
Suite 100
Newport Beach, CA 92660

`

Web: www.pacifictrack.com
Email: [e-mail]

PT30

User Manual

Introduction

The Pacific Track PT30 is an Electronic Logging Device (ELD) that can be used to implemented
the Federal Motor Carrier Safety Administration (FMCSA) Hours Of Service (HOS)
requirements.

The PT30 includes 4 major functional blocks:

 A GPS receiver
 A CAN transceiver
 Memory Storage
 A Bluetooth Low Energy (BLE) transceiver

Interface

The PT30 includes a single 10-pin interface. The PT30 must be connected to the vehicle
diagnostic port with the supplied cable. The diagnostic connector provides power (typically 12V)
and connection into the vehicle CAN bus.

Bluetooth Low Energy

The Bluetooth Low Energy implements the Low Energy section the Bluetooth 4.0 specification.
The transceiver operates between 2402 MHz and 2480 MHz at a power of -4 dBm. The antenna
is integrated on the Printed Circuit Board (PCB) of the PT30. There are no serviceable or
adjustable parts inside the product. Any modification of the product will void the warranty.

OEM labeling responsibilities

The Pacific Track PT30 is certified by the FCC Rules and Regulations Part 15 subpart C. It is the
responsibility of the OEM or integrator to include the following labeling text in the end user
manual:

FCC ID: 2ALBDPT30

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation.

In addition, the following text shall also be part of the user manual:

This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

* Consult the dealer or an experienced radio/TV technician for help.

In order to maintain compliance with FCC regulations, shielded cables must be used with
this equipment. Operation with non-approved equipment or unshielded cables is likely to
result in interference to radio and TV reception. The user is cautioned that changes and
modifications made to the equipment without the approval of manufacturer could void the
user's authority to operate this equipment.