Pacific Cycles Handy Upright User Manual

Upright

Owner manual

Handy Recumbent Assembly Procedures
Step 1:

Take out all parts in the box: (1) Seat assembly,
(2) Back support, (3) Luggage rack, (4) 2 rear
wheels, (5) Front frame assembly, (6) Foot rest,
(7) Main frame, (8) Front frame fixing plate set,
(9) Seat assembly fixing plate set, (10) Luggage
rack / rear wheel axle fixing plate set, (11) Wheel
skewers and hub covers.

Step 2:

Join together the front frame, foot rest and main
frame: Assemble the foot rest to the front frame,
and slide the main frame into the clamp as shown
in the picture. Adjust the wheel base to the desired
dimension and tighten.

Step 3:

Assemble the luggage rack and rear wheels:
Push down the head of the skewer; insert the
skewer through the rear hub and into the rear
axle, put on the hub cover.

Step 5:

Assemble the seat to the main tube at the desired
position,

adjust the back support angle and tighten.

Step 4:

Assemble the back support according to the
following picture.

Step 6:

Assemble the hand pedals.

Step 7:

Before riding, make sure all bolts are properly
tightened.

Important Safety Checklist!

Check and make sure that all clamps and QR are properly tightened.
Always wear a helmet and abide by all traffic regulations and courtesies!

Important Maintenance Checklist!

1st service inspection after at most 300 km or at latest one months after purchase,
repeat every 3 months.
Parts need lubrication: chain, headset, bearings.
Parts prohibit lubrication: seatpost, seat tube, adjustable stem, rims.
Repeat lubrication every half month or after at most 150 km ride.
Apply lubrication immediately after washing or riding in rainy day.

236 Hsia Chuan Tze, Yung An,
Hsin Wu, Taoyuan, Taiwan
Tel: [phone] Fax: [phone]
Web: http://www.pacific-cycles.com
Email: [e-mail]