Thank you for choosing a Pacifi c Currents Product.
Please make sure you have carefully read and understood
these assembly instructions before you begin.
Pre-Assembly Steps
Prepare the work area:
First, compare the parts in the box with the parts list on the following pages and
make sure that none are missing. If you discover any missing parts, please visit
www.pacifi ccurrentsinc.com or call (877) 276-1486.
will need this to obtain service.
Choose and measure the fi nal locaƟ on where you would like to place the prod-
uct and ensure that it will fi t a 10’ x 13’ rectangle with 10’ height clearance. Then,
choose an assembly area as close as possible to this fi nal loca on and large enough
to layout and pre-assemble all the parts for this Gazebo.
Save your sales receipt
as you
It is highly recommended that you cover the work surface with a tarp or other fabric
to prevent scratches to the fi nish or other damage during assembly.
You will need these addi onal tools: a ladder and an adjustable wrench.
You may also need these addi ontal tools (op onal): work gloves, waterproofi ng
spray.
General Notes:
1. You will need the help of another person to assemble this product. Please ask a
friend or neighbor for assistance!
2. Once a unit has been pre-assembled in each step, please set it aside un l further
instruc ons.
3. For all customers, we highly recommend that you remove your canopy top in
cases of severe inclement weather such as thunderstorms. Damage due to acts of
nature are not covered in the warranty.
4. You do not need to disassemble the gazebo during winter months. However, to
prevent damage to the frame and canvas top due heavy snow loads, remove the
canvas top and store it in a dry loca on un l spring.
22012 PC-15000
Page 3
A
x 4
Parts Iden fi ca on
(Note: Not drawn to Scale)
C
x 2
B
x 2
G
x 4
D
x 2
F
x 1
E
x 2
PC-15000 2012 3
Page 4
I
x 4
X
x 8
J
x 4
L
x 1
K
x 4
x 1
M
W
x 8
42012 PC-15000
Page 5
O
N
x 1
x 1
***Important***
For missing or defecƟ ve parts, Do NOT return to the place of purchase. Call our toll free
number below or visit www.pacifi ccurrents.com. Please have your sales receipt ready
when you call.
888-474-2770
PC-15000 2012 5
Page 6
Hardware Iden fi ca on
Bolt Set
Q
Bolt Set
R
Bolt Set
S
M6 x 15mm Length Bolt
[x 16]
M6 x 40mm Length Bolt
[x 16]
M6 x 50mm Length Bolt
[x 8]
How to use Hardware
Bolt and Washer Assembly
(Parts Q and R)
Bolt and Washer Assembly
(Part S)
Snap on Nut Cap
Washer
WasherWasher
Snap on Bolt Cap
62012 PC-15000
Page 7
Step 1
Assemble the Main Beams [x 4]
BDCE
Assembly Instruc ons
[x 2][x 2][x 2][x 2]
S
D
D
[x 8]
S
E
E
V
S
V
PC-15000 2012 7
T
T
Page 8
Step 2
Assemble the Four Main Beams to Poles [x 4]
A
[x 4][x 2][x 2]
R
B & CD & E
[x 16]
R
A
B + C
D + E
B + C
A
D + E
A
82012 PC-15000
Page 9
Step 3
Assemble the Corner Bars to Top and Main Beams [x 4]
FG
[x 4]
[x 2]
J
[x 4]
Q
[x 8]
NOTE: Before performing Step 3, make sure all
instances of Part X are in place. See Part X replacement instruc ons below:
The original locations & Desc of Snap lock
Location
Top connector
Desc
Tool Description
PictureDescription
Ground stake
(In the
hardware kit for
original
Gazebo)
1. If snap lock is missing, please
install it as shown:
Push the snap lock into the tube
using the ground stake.
OK!
PC-15000 2012 9
Step 1:
Step 3:
Push in the snap lock using a
ground stake.
Install new snap lock using
ground stake.
2. If snap lock is damaged, please
replace it as shown.
Step 2:
OK!
Push the damaged snap lock into
the part using ground stake.
Page 10
Step 4 Con nued
Assemble Corner Bars to Top and Main Beams [x 4]
J
F
J
G
102012 PC-15000
Page 11
Step 4 Con nued
Assemble Corner Bars to Top and Main Beams [x 4]
Q
G
F
F
G
Q
PC-15000 2012 11
Page 12
Step 5
Assemble the Top Middle Link Rod to Top Connector [x 4]
IK
[x 4][x 4]
Q
[x 8]
F
I
I
I
K
K
I
Q
K
122012 PC-15000
Page 13
Step 6
Stake the Poles [x 4]
W
[x 8]
W
Step 7
AƩ ach the Cover [x 1]
L
[x 1]
L
PC-15000 2012 13
Page 14
Step 8
AƩ ach Top Cover to Cover [x 1]
M
[x 1]
M
L
M
A ach air vent ne ng
onto canopy with velcro
L
142012 PC-15000
Page 15
Step 9
Unzip Bug Screen Neƫ ng into 4 Pieces
N
[x 1]
N
UnzipUnzipUnzip
N
PC-15000 2012 15
Page 16
Step 10
A ach and Secure Bug Screen Ne ng
(Op onal) Install bug screen and/or sun shade
N
Inside
Tie ne ng onto
colums using
cords.
Inside
162012 PC-15000
Outside
Page 17
Step 11
Unzip Sun Shade to 4 Pieces
O
[x 1]
O
UnzipUnzipUnzip
O
PC-15000 2012 17
Page 18
Step 12
A ach and Secure Sun Shade
(Op onal) Install bug screen and/or sun shade
O
Outside
Tie ne ng onto
colums using
Outside
182012 PC-15000
Inside
cords.
Page 19
Step 13
Zip Sun Shade Pieces Together
Zip 2 pcs ne ng
together
Outside
O
Outside
O
Slide ne ng
to corners if
desired.
PC-15000 2012 19
Page 20
OPTION A
Zip Up Bug Screen, Tie Back Sun Shade
Inside
N
N
If desired, use straps to
keep Sun Shade open
Zip 2 pcs ne ng
together
202012 PC-15000
Page 21
OPTION B
Open Both Bug Screen and Sun Shade
N
Inside
Tie 2 pcs ne ng
together
Slide ne ng
to corners
PC-15000 2012 21
Page 22
FAQ (Frequently Asked QuesƟ ons)
Q: Will the gazebo frame ever rust?
A: The powder coated fi nish of the metal frame prevents rus ng so long as the metal itself is
not exposed. Exposure of the metal may occur due to accidental scratches or long-term wear
and tear. Occasional touch ups to aff ected areas with weatherproof paint will ensure many
years of con nued enjoyment from your gazebo.
Q: Can I use grills or barbecues inside the gazebo?
A: No, we do not recommend this. While the canopy top is fabricated using a fi re resistant
material, our gazebos are not designed to accomodate an open fl ame. Please refrain from
using your grill inside the gazebo.
Q: Will the gazebo move or blow away in strong winds?
A: Several features of our design were considered to allow the gazebo to remain very stable
across a range of weather condi ons. The four vents in the canopy top help to allow low to
medium winds to pass through the covering.
However, if you install the gazebo in an area where strong winds are persistent, it is advisable
to take further steps to fasten the gazebo to the ground. If the gazebo is installed over a so
natural surface (grass or dirt), you may drive metal stakes (included) through the holes located
at the bo om of the panels and into the ground. If the gazebo is installed over a hard surface
(wooden decks or concrete pa os) it will be necessary to separately purchase screws or bolts
and nuts to affi x the frame to your installa on surface. Please visit your local Mills Fleet Farm
Store for more op ons.
Q: I like being outdoors, but cannot stay for long because of mosquitoes. Are bug screens
available for my gazebo?
A: Yes! Bug screens for all gazebo models are available separately for purchase as an
accessory.
Care Instructions:
Canvas Top:
The polyester top (Canvas Top) can be machine washed using a small amount of detergent. Do not
machine dry or use bleach for the Top. Top may also be spray-rinsed while attached to Gazebo and
lightly scrubbed with a soft broom. DO NOT use any hard abrasives to scrub.
The canvas top is not waterproof. However, a waterproofi ng spray (not included) may be used to
prevent rain water infi ltration.
The canvas top MUST be removed and stored in a dry location in the event of snow fall. Accumulated
222012 PC-15000
Page 23
snow WILL severely damage your gazebo if the canvas top is not removed.
Gazebo Frame:
Any rust on the frame as a result of scratches on the surface can be cleaned with soap and water
and wiped down with a soft cloth. DO NOT use any hard abrasives to scrub. Touch-up paint is not
available but the colors can be matched at your local hardware store.
All metal parts may be sprayed with a clear laquer fi nish to maintain the attractiveness of your gazebo
over time and allow you to enjoy your gazebo for as long as possible.
Woven Wicker Surfaces:
Please clean regularly with fresh soapy water and dry using a damp soft clean cloth monthly or as
often as necessary
IMPORTANT - Winter storage: If you live in an area that experiences snow in the winter, remove
the canvas top and store it in a location that is dry and free of moisture.
1 Year Limited Warranty:
A. Purchaser assumes all risk in the assembly and use of this unit.
B. *** A claim under our warranty must be submitted by the original purchaser to Pacifi c Currents Inc.,
via email, website, or fax within 24 hours of the defect occuring and within 12 months of the date of
purchase, validated by providing a copy of the original sales receipt, a photograph of the damaged area
and a brief description. ***
C. All components carry a one year limited warranty from date of purchase against defects in material and
workmanship arising under normal use. This warranty does NOT cover wear and tear, nor weathering due
to climate and other environmental factors, nor does it cover failure resulting from accident, misuse,
neglect , mishandling, modifi cation, or damage that is attributed to acts of nature (high winds, rain, snow,
etc.). This warranty does not cover incidental or consequential damages resulting from use of product, or losses
arising out of any breach of this warranty.
D. Fulfi llment of this warranty shall only include direct replacement of damaged parts as described above to be
arranged at the discretion of Pacifi c Currents Inc. If it is not feasible or practical to replace the damaged part
directly, Pacifi c Currents Inc. shall arrange a return of merchandise or replacement between the purchaser and
the place of purchase.
Please contact us should you have any questions concerning assembly, care information, warranty
coverage, and missing or defective parts.
Email: info@pacifi ccurrentsinc.com
Customer Service:
Website: www.pacifi ccurrentsinc.com
(877) 276-1486
PC-15000 2012 23
Enjoy your new gazebo and thank you for
choosing a Pacifi c Currents Inc. product!
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.