Pacific PPR2B, PPR3B, PPR4B User Manual

USERS MANUAL

PLATFORM BIKE CARRIER

PPR4B

4 BIKE CARRIER

PPR3B

3 BIKE CARRIER

PPR2B

2 BIKE CARRIER

Note: Lights have now been upgraded to LED

4

Bike carrier (PPR4B) used for illustration purposes

Page 2

Supplied with 7 pin round plug and
7 pin flat plug adaptor if required.

Page 3

License plate can be fitted to light board

Page 4

License plate can be fitted to light board

Clean tow ball

Unlock key lock.

Lift lever to open position.

Fit to tow ball and lower
lever to closed position.

Check to make sure
carrier is secure.

Tow ball bracket can be adjusted for a more secure fit.

For a

looser

fit on

tow ball

rotate

cup

in the
indicated
direction.

For a

tighter

fit on

tow ball

rotate

cup

in the
indicated
direction.

Push and

twist to lock.

Page 5

Page 6

Frame tube diameter

min ø 30mm

max ø 50mm

Adjust wheel cradle by loosening fixing screw. Then

tighten once in desired position. Tighten straps firmly.

Loading Procedure

When loading bike carrier

always start with the closest

cradle to the vehicle.

Fixing screw

Page 7

1. Push bike towards vehicle

2. Press tilt lever.

3. Allow bikes to tilt back.

Tilt lever

How to tilt

www.bikecorp.com.au

P.O. Box 1620 Clayton South, Vic, 3169

SAFETY

Carefully read all of these instructions and safety recommendations before assembling
and using this bike carrier.

Total combined bike and rack weight must not exceed total rated maximum of tow ball.
Individual bike weight must not exceed 15kg.
Warning: Check the vehicle manufacturers’ maximum axle load is not exceeded when the bikes are loaded
onto the bike carrier.
Opening mechanism: Always make sure that the opening mechanism is closed and fastened.
Warning: Check the tow bar manufacturers’ maximum bearing load recommendations for your tow bar are
not exceeded when the bikes are loaded onto the carrier.
Warning: Ensure the bike carrier is securely fastened to the tow ball before use.
Warning: The bike carrier may partially or completely obscure the vehicles number plate.
Warning: Check the local laws in your state or territory regarding number plates for bike carriers.
Warning: Never exceed 120km/h when transporting bikes on this carrier.
Warning: Ensure bike carrier is well clear of the exhaust pipe of your vehicle.

Driving Tips With Bike Rack Fitted To Your Vehicle.
Avoid rapid acceleration.
Avoid high speeds in sharp turns.
Avoid high speeds when driving on rough road surfaces.
Check all fastening mechanisms, (screws, straps, nuts) regularly to ensure they are tight.
The bike carrier adds length and width to your vehicle. Use extreme caution when manoeuvring your vehicle
in tight spaces, especially when reversing.
Turn off your vehicle and ensure the handbrake is on before fitting the carrier to your vehicle.
Do not clean the bike carrier with corrosive cleaners or solvents. Use a damp soft cloth to wipe it down. Re­move the bike carrier from the vehicle before washing the vehicle. Do not enter an automatic car wash with
the bike carrier attached to the vehicle.
To preserve screws please lubricate with oil.