Pach and Company NPB7000 User Manual
INSTALLATION AND PROGRAMMING MANUAL
Rev. 03-04-2011
TABLE OF CONTENTS
Chapter 1
GETTING STARTED -------------------------------------------------------------- 4
Chapter 2
INSTALLATION WIRING DIAGRAM ---------------------------------------- 11
Chapter 3
PROGRAMMING ------------------------------------------------------------------ 13
Chapter 4
SYSTEM’S OPERATION -------------------------------------------------------- 23
Chapter 5
TROUBLE SHOOTING GUIDE ------------------------------------------------ 25
GENERAL FCC REQUIREMENTS ------------------------------------------- 27
QUICK GUIDE ---------------------------------------------------------------------- 28
AeGISNPB7000P Page 2
LIMITATIONS OF LIABILITY
This manual is subject to change without notice.
Pach and Company is not liable for any errors that might occur from use of this document, nor is any
commitment to update the information herein implied.
Pach and Company does not assume any liability for any damages, which may arise in installation or use of
the AeGIS NPB7000P Series. Pach and Company does not assume liability for any incompatibility between the
AeGIS NPB7000P Series and users devices.
Pach & Company reserves the right to make changes without prior notice to any products in order to improve
reliability, function or design.
AeGISNPB7000P Page 3
Chapter 1
GETTING STARTED
Introduction
Pach & Company thanks and congratulates you on the purchase of your AeGIS NPB7000P Series Telephone
Entry Access Control Systems.
The manual is designed to guide you through the proper programming and use of the AeGIS NPB7000P
Series. It is important for you to read and follow the manual completely.
The Aegis NPB7000P Series comes with two years warranty
System Description, Specifications and Accessories
AeGIS 7000P Series utilizes microprocessor technology to provide security as well as convenience to you. It is
designed for residential and commercial buildings, military and government sites, industrial facilities, or any
location where access control is required. It uses a dedicated phone line and connects to the public telephone
network. Authorization for access control is through the telephone line, or with the tenant's own access code,
which is entered on the system keypad. The tenants MUST have a telephone to allow remote visitor access.
Also, as a standard feature, the tenant is allowed to "call" the Aegis unit and converse with the visitor using a
touch tone phone.
The system parameters and tenants data will be entered via the keypad and the LCD provides easy display.
Non-volatile technology is used for AeGIS7000P series. The tenant database will not be lost during a power
failure.
Standard features:
o Program and store the tenant's name, directory code, telephone number and personal access
code.
o Unlocking door or gate remotely by the tenant using his or her telephone keypad.
o Unlocking door or gate by the tenant using his or her own private access code.
o Built-in back-light LCD directory, Postal Switch.
o Works behind a PBX to dial extensions (analog only).
o Keypad Activated to support Voice Mail.
Programmable features
o 2, 3 or 4 digit directory code
o Lock out count
o Manual Unlock-Auto, count-down timer re-lock.
o 4-digit unit master code protection
o Open Interval
o Talk Time timer
AeGISNPB7000P Page 4
Technical Specifications
o Power Input: 12 VAC 40 VA (supplied) or 12 VDC 40VA UL Listed Transformer
o Current Consumption: 500mA idle, 700mA operation
o Emergency Battery: 12Vdc, 4Ahr rechargeable (not supplied)
o Telephone Line: Standard voice grade RJ11 jack.
o Night Light: 14V 0.080A 15,000 Average life hours.
o Operating Environment: Temp. 32°F to +140°F Relative Humidity 0% to 95% non-condensing.
Heater Pad (AHP5) is required if the ambient temperature is below 32°F.
o Relay Output: Form C Dry Contact 120 VAC 10A/ 24VDC 10A/ 250VAC 7A
o Memory Type: Non-volatile
o Tone Detection: Crystal controlled, capable of detecting short bursts 80 ms
o Ringer Equivalence: 0.6B
o Mounting: Surface or Full-Flush.
o Construction: 16-gauge stainless steel
o Shipping: 11 lbs. or 5 kg. Approximate
Specifications subject to change without prior notice
Accessories and Replacement Parts
Visit our website www.pach-co.com or call 1-888-678-7224
Unpacking the System
All the items below come with the AeGIS NPB7000P Series. If you have missing items, please contact
your distributor or Pach and Company at (888) 678-7224.
AeGISNPB7000P Page 5
Limited Warranty
Pach and Company new products are warranted to be free of defects in material or workmanship for a
period of 24 month from the date of purchase. This warranty extends only to wholesale customers who
buy direct from Pach and Company or through Pach and Company’s normal distribution channels.
Pach and Company does not warrant this product in any way to the end user consumer. Consumers
must obtain warranty information from the selling dealer and/or installer as to the nature of the dealer’s
warranty, if any. All contact to Pach and Company from the end user consumer will be referred to the
consumer’s selling dealer and/or installer.
AeGISNPB7000P Page 6
There are no obligations and/or liabilities on the part of Pach and Company for consequential damages
arising out of or in connection with use or performance of Pach and Company products or other
indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or
reinstallation. Any use or change to Pach and Company products not expressly approved by the
manufacturer, and performed by an authorized dealer/installer will immediately void the warranty. All
implied warranties, including warranties for marketability as well as implied warranties for suitability, are
valid only until the warranty expires or is voided, whichever comes first.
This Pach and Company Limited Warranty is in lieu of all other warranties express or implied and all
Pach and Company warranties are subject, but not limited, to the following conditions.
New Product Policy
o The products must be properly installed as specified; and maintained or used as intended.
o Cause of product failure is not due to vandalism or malicious mischief, improper installation,
abnormal physical or electrical stress, lightning, power surges, misuse, negligence, accidents,
or Natural disasters.
o Warranty is immediately null and void if the product has been altered, repaired, or modified
without express written authorization from Pach and Company Technical Department, with such
authorization given only to manufacturer approved dealer/installers.
o Under no circumstances will Pach and Company honor warranty any product found to have
been altered, repaired, and/or modified by the end-user consumer.
o Pach and Company reserves the right to repair the product, or replace a warranted product with
a like product of equal value in the event original product cannot be repaired.
o Distributors and/or Dealer-Installer must first obtain a Return Merchandise Authorization (RMA)
number from Pach and Company Technical Department before returning any product to factory
for repair, whether under warranty or not. No returns accepted without RMA.
o Return Merchandise Authorization (RMA) numbers will not be issued to the end-user
consumers. Consumers must contact their selling dealer-installer for any/all warranty issues.
o Distributor and/or Dealer-Installer are responsible for all shipping charges, incl. freight and
insurance fees, for products shipped to Pach and Company repair center.
o Pach and Company warranty does not guarantee any product to be free of operation error or
service interruption in any way during the course of daily product operation.
o Pach and Company is not responsible for time, travel, and/or labor costs of any distributor
and/or dealer-installer, including but not limited to, any expenses to install, uninstall or reinstall
hardware/software/firmware related to warranty issues, product enhancements, or product
failures.
New Product Warranty Exception
Wiegand card, keyfob and transmitter
Pach and Company warrants the wiegand card, clam, and keyfob to be free of defects in material or
workmanship for a period of three (3) months from the date of invoice. The above warranty is subject
to the following conditions.
AeGISNPB7000P Page 7
o The products must be properly installed as specified; and maintained or used as intended
Cause of product failure is not due to vandalism or malicious mischief, improper installation,
abnormal physical or
o electrical stress, lightning, power surges, misuse, negligence, accidents, or Natural disasters
o Warranty is immediately null and void if the product has been altered, repaired, or modified
without express written authorization from Pach and Company Technical Department, with such
authorization given only to manufacturer approved dealer/installers
o Under no circumstances will Pach and Company honor warranty any product found to have
been altered, repaired, and/or modified by the end-user consumer.
o Pach and Company reserves the right to repair the product, or replace a warranted product with
a like product of equal value in the event original product cannot be repaired.
o Distributors and/or Dealer-Installer must first obtain a Return Merchandise Authorization (RMA)
number from Pach and Company Technical Department before returning any product to factory
for repair, whether under warranty or not. No returns accepted without RMA.
o Return Merchandise Authorization (RMA) numbers will not be issued to the end-user
consumers. Consumers must contact their selling dealer-installer for any/all warranty issues.
o Distributor and/or Dealer-Installer are responsible for all shipping charges, incl. freight and
insurance fees, for products shipped to Pach and Company repair center.
o Pach and Company warranty does not guarantee any product to be free of operation error or
service interruption in any way during the course of daily product operation.
o Pach and Company is not responsible for the time, travel, and/or labor costs of any distributor
and/or dealer-installer, including but not limited to, any expenses to install, uninstall or reinstall
hardware/software/firmware related to warranty issues, product enhancements, or product
failures.
AeGIS Parts Limited Warranty
Pach and Company parts are warranted to be free of defects in material or workmanship for a period of
six (6) months), from the date of purchase or repair. This warranty extends only to wholesale
customers who buy direct from Pach and Company or through Pach and Company’s normal distribution
channels. Consumers must obtain warranty information from the selling dealer and/or installer as to the
nature of the dealer’s warranty, if any. All contact to Pach and Company from the end user consumer
will be referred to the consumer’s selling dealer and/or installer.
This Pach and Company Limited Warranty is in lieu of all other warranties express or implied and all
Pach and Company warranties are subject, but not limited, to the following conditions.
Replacement Parts
o The products must be properly installed as specified; and maintained or used as intended.
o Cause of product failure is not due to vandalism or malicious mischief, improper installation,
abnormal physical or electrical stress, lightning, power surges, misuse, negligence, accidents,
or Natural disasters.
o Warranty is immediately null and void if the product has been altered, repaired, or modified
without express written authorization from Pach and Company Technical Department, with such
authorization given only to manufacturer approved dealer/installers.
AeGISNPB7000P Page 8
o Under no circumstances will Pach and Company honor warranty any product found to have
been altered, repaired, and/or modified by the end-user consumer.
o Pach and Company reserves the right to replace a warranted product with a like product of
equal value in the event original system cannot be repaired.
o Distributors and/or Dealer-Installer must first obtain a Return Merchandise Authorization (RMA)
number from Pach and Company Technical Department before returning any product to factory
for repair, whether under warranty or not. No returns accepted without RMA.
o Return Merchandise Authorization (RMA) numbers will not be issued to the end-user
consumers. Consumers must contact their selling dealer-installer for any/all warranty issues.
o Distributor and/or Dealer-Installer are responsible for all shipping charges, incl. freight and
insurance fees, for products shipped to Pach and Company repair center.
o Pach and Company warranty does not guarantee any product to be free of operation error or
service interruption in any way during the course of daily product operation.
o Pach and Company is not responsible for time, travel, and/or labor costs of any distributor
and/or dealer-installer, including but not limited to, any expenses to install, uninstall or reinstall
hardware/software/firmware related to warranty issues, product enhancements, or product
failures.
AeGIS Non-warranty repair limited warranty
Non-warranty repair policy
Pach and Company warrants repairs to be free of defects in material or workmanship for a period of
three (3) months from the date of repair and invoice. This warranty extends only to wholesale
customers who buy direct from Pach and Company or through Pach and Company’s normal distribution
channels. Consumers must obtain warranty information from the selling dealer and/or installer as to the
nature of the dealer’s warranty, if any. All contact to Pach and Company from the end user consumer
will be referred to the consumer’s selling dealer and/or installer.
This Pach and Company Limited Warranty is in lieu of all other warranties express or implied and all
Pach and Company warranties are subject, but not limited, to the following conditions.
o The products must be properly re-installed as specified; and maintained or used as intended.
o Cause of repaired product failure is not due to vandalism or malicious mischief, improper
installation, abnormal physical or electrical stress, lightning, power surges, misuse, negligence,
accidents, or Natural disasters.
o Warranty is immediately null and void if the product has been altered, repaired, or modified
without express written authorization from Pach and Company Technical Department, with such
authorization given only to manufacturer approved dealer/installers.
o Under no circumstances will Pach and Company honor warranty of any product found to have
been altered, repaired, and/or modified by the end-user consumer.
o Pach and Company reserves the right to replace a previously repaired product with a like
product of equal value in the event of repair failure, provided repair failure occurs within the
specified warranty period.
o Distributors and/or Dealer-Installer must first obtain a Return Merchandise Authorization (RMA)
number from Pach and Company Technical Department before returning any product to factory
for non-warranty repair. No repair returns accepted without RMA.
AeGISNPB7000P Page 9
Loading...