PAC Audio RPK4-FD2101 Technical Bulletin

Powering Factory USB Port

Aftermarket

Radio Harness

FD2A-USB-PWR-HAR

FD2A-RS-HAR

Technical Bulletin

In RPK4-FD2101

Important Notes:

This technical bulletin only applies to RPK4-FD2101 kits that have harness with label FD2A-RS-HAR included.

Issue:

Factory USB port is no longer powered or functional upon removing the factory radio.

Solution:

By using the crimped wires included, insert pins into two of the receptacles in the 54-pin connector(pins 8 & 38) that
are used to supply +12V and Ground to the factory USB port, thus making it functional once again.

STEP 1

IDENTIFY THE RECEPTACLES YOU WILL BE ADDING PINS
INTO ON THE 54-PIN CONNECTOR.

STEP 2

INSERT PINS INTO RECEPTACLES 8 AND 38 WITH LOCKING
TABS FACING EDGE OF CONNECTOR.

STEP 3

ENSURE PINS ARE SEATED FIRMLY INTO POSITION.
PINS WILL “CLICK” INTO THE RECEPTACLE.

© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.

STEP 4

CONNECT LOOSE WIRE ENDS TO ACCESSORY 12V+ AND
GROUND AT AFTERMARKET RADIO HARNESS.

PAC-audio.com

Rev: V1

Date: 061919