PAC Audio RPA-VA1 Instruction Manual
Dierential to Single Ended
RPA-VA1
Video Converter / Video Noise Filter
Introduction & Features
The RPA-VA1 is a dierential to single ended video converter. It is designed for use when installing an aftermarket
radio into a vehicle that uses a dierential camera. The RPA-VA1 can also be used as a video noise lter in cases
where the camera ground is on a dierent plane than the aftermarket radio, by eliminating the ground loop and xing
distortion such as horizontal lines in the video.
Important Notes
1. It is very important that you connect the RPA-VA1 ground wire to the aftermarket radio's ground wire. These two
components sharing the same ground is critical to the noise lter feature.
2. The video input connector has 2 independent wires for when you are connecting to a factory reverse camera. The RCA
end can be cut o and the harness wires connected directly to the vehicle.
Wiring Connection Chart
Video In
Yellow (Video +)
Black (Video -)
Video Out
Black (Ground -)
Red (Acc 12v+)
RPA-VA1
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Rev: V3
Date: 060719
Page 1
Loading...