Page 1
LINK
ASSEMBLY & INSTALLATION INSTRUCTIONS
INFO@PABLODESIGNS.COM
888 MARIN STREET
SAN FRANCISCO, CA
94124
PABLODESIGNS.COM
pg. 1
Page 2
FLOOR BASE
ASSEMBLY INSTRUCTIONS
LINK MODELS
LINK
SMALL TABLE SMALL WALL MOUNT
MEDIUM TABLE MEDIUM WALL MOUNT MEDIUM CLAMP MOUNT
FLOOR BASE ASSEMBLY
SMALL CLAMP MOUNT
CLAMP MOUNT
MEDIUM FLOORSMALL FLOOR
pg. 2
WORK SURFACE CLAMP RANGE: 1/2” - 2 1/4”
TOOL NEEDED: 5mm HEX KEY
Page 3
WALL MOUNT
ASSEMBLY INSTRUCTIONS
WALL MOUNT
B
A
E
F
D
C
PARTS LIST:
A. WALL MOUNT BODY
B. SCREWS
C. MOUNTING PLATE
D. WALL ANCHORS
E. SET SCREW
F. HEX TOOL
LINK
USE THE MOUNTING PLATE AS A TEMPLATE FOR MARKING
1
THE WALL ANCHOR LOCATION.
PLACE THE MOUNTING PLATE
IN THE DESIRED LOCATION.
MAKE SURE IT IS ALIGNED
VERTICALLY.
MARK THE CENTER OF THE
TWO VERTICALLY ALIGNED
HOLES. THE OTHER HOLES
WILL NOT BE USED
REMOVE THE PLATE FROM THE WALL AND INSTALL
2 3
2
BOTH WALL ANCHORS.
TAP THE UNTHREADED TIP
OF THE ANCHOR INTO THE
WALL.
USE A PHILLIPS SCREWDRIVER
TO COMPLETE THE ANCHOR
INSTALLATION.
HANG THE WALL MOUNT BODY ON THE
4
4
MOUNTING PLATE AND TIGHTEN THE
SET SCREW.
THIS SURFACE SHOULD
BE FLUSH WITH THE WALL.
ROUTE THE POWER CABLE UP THROUGH THE HOLE AND PLUG INTO
5
5
LAMP BEFORE INSERTING THE LAMP INTO THE MOUNT.
SCREW THE MOUNTING PLATE TO THE ANCHORS WITH
3
THE SCREWS PROVIDED.
THIS ARROW POINTS UP
IMPORTANT: SET SCREW MUST BE TIGHT
pg. 3
Page 4
POWER SUPPLY & ADJUSTMENTS
ASSEMBLY INSTRUCTIONS
LINK
POWER SUPPLY
PLUG CORD INTO LAMP FROM BELOW
USE ONLY PABLO POWER SUPPLY PROVIDED
HEAD TENSION ADJUSTMENT ARM TENSION ADJUSTMENT
TOOL NEEDED: #1 PHILLIPS SCREWDRIVER
TOOL NEEDED: KEY PROVIDED UNDER BASE
THESE 4 SCREWS MAY BE ADJUSTED IF LAMP
HEAD WILL NOT STAY IN DESIRED POSITION
CARE INSTRUCTIONS
WIPE CLEAN WITH A SOFT DAMP CLOTH.
AVOID AMMONIA-BASED CLEANERS.
pg. 4
TABLE BASE KEY STORAGE
KEY SHIPS WITH ALL MOUNTING OPTIONS
Page 5
USB ADD ON
ASSEMBLY INSTRUCTIONS
INSTALLATION OF LINK USB
LINK
CONNECT USB PORT TO LAMP
pg. 5
CONNECT POWER TO USB PORT
Loading...