P1PE P5200EA User Manual

FOR YOUR SAFETY

Keep this manual for future reference.

You must read and understand
this manual before use.

1

INDEX

1

2

3

4

5

6

CONTENTS

SAFETY

PART LOCATIONS

QUICK START GUIDE

STARTING PROCEDURE

PAGE NO.S

3 - 7

8

9 - 10

10 - 11

STOPPING PROCEDURE 11

USING THE MACHINE 12 - 14

7

8

9

10

11

12

13

MAINTENANCE 15 - 19

STORAGE 19

TROUBLESHOOTING 20

SPECIFICATION 21

DECLARATION OF CONFORMITY 22

RECYCLING & PRODUCT DISPOSAL 23

MANUAL UPDATES 24

14 WARRANTY 24

15 CONTACT DETAILS 24

2

1.1 General Safety Notes.

1.2 The operator of the machine is responsible for, and has a duty of care in making sure

that the machine is operated safely and in accordance with the instructions in this
user manual. Keep the manual safe and pass it on if the machine is loaned or sold to
another user.

1.3 Please note the following safety points.

1.4 The machine should never be left it in a condition which would allow an untr ained or

unauthorised person/s to operate this machine.

1.5 All due care and diligence should be taken by the operator for the safety of and with
regard to those around whilst using the machine.

1.6 Some or all of the following - warning signs, symbols and/or PPE pictograms may

appear throughout this manual. You MUST adhere to their warnings. Failure t o do
so may result in personal injury to yourself or those around you.

DANGER

Indicates a hazard, which, if not avoided, could result in serious injury or death.

WARNING

Indicates a hazard, which, if not avoided, could result in serious injury.

CAUTION

Indicates a hazard which, if not avoided, might result in minor or moderate injury.

NOTE

Indicates a situation that could easily result in equi pm ent da mag e.

READ and keep the manual safe and pass it on if the machine is loaned or sold to another user.
You MUST fully understand all instructions to ensure you use and operate the machine safely.

Appropriate Personal Protective Equipment (PPE), MUST be worn at all times when operating or
repairing the machine.

3

1.10 Carbon Monoxide (where applicable).

1.11 Carbon monoxide is a colourless and odourless gas. Inhaling this gas can cause

death as well as serious long term health problems such as brain damage.

1.12 The symptoms of carbon monoxide poisoning can include but are not limited to the

following;
Headaches, dizziness, nausea, breathlessness, collapsing or loss of consciousness.

1.13 Carbon monoxide poisoning symptoms are similar to flue, food poi soning, viral

infections and simply tiredness. It is quite common for people to mistake this very
dangerous poisoning for something else.

1.14 To avoid carbon monoxide poisoning DO NOT use Petrol/Diesel powered equipment

inside any of the following; Home, garage, tent, camper van, mobile home, caravan
or boat. This is not exhaustive and if you are in any doubt contact your dealer.

1.15 If you think you have or someone around you has been affected by carbon monoxide

poisoning;

1.16 Get them fresh air immediately, by leaving the affected area or by opening doors and

windows. If safe and practical to do so make sure that the machine is turned off.
DO NOT enter a room you suspect of having carbon monoxide present – instead call
the emergency serv i ces.

1.17 Contact a Doctor immediately or go to Hospital – let them know that you suspect

carbon monoxide pois oni ng .

1.18 DO NOT use in an enclosed area or moving vehicle.

1.20 General Fuel Safety (where app licable).

CAUTION

ALL FUELS ARE FLAMABLE

1.21 Fire Hazard – keep fuel away from all sources of ignition for example heaters.

Lamps, sparks from grinding or welding.

1.22

1.23 ALWAYS keep the work area tidy.

DO NOT carry out hot work on tanks that have contained fuel.

4

1.24 ALWAYS clean up spills promptly using absorbent granules and a lidded bin.

1.25 ALWAYS dispose of waste fuels correctly.

1.30 Fueling/De-fueling (where applicable).

CAUTION

ALL FUELS ARE FLAMABLE

1.31 ALWAYS fuel and defuel in a well ventilated area outside of buildings.

1.32 ALWAYS wear correct, suitable and fit for purpose Personal Protective Equipment

(PPE), suggested items are but not limited to safety gloves, overalls.

1.33 When fueling/de-fueling ALWAYS avoid inhaling fumes.

1.34 When de-fueling ALWAYS use a proper fuel retriever.

1.35 ALWAYS carry fuel in the correct and clearly marked container.

1.40 Electrical Safety )where applicable).

1.41 Electricity can kill – NEVER work on LIVE/ENERGISED equipment.

1.42 Prior to carrying out any maintenance work you MUST identify electrical isolation

methods and isolate all electrical supplies.

1.43 Prior to use and with all electrical supplies isolated, you MUST check all electrical

cables, plugs and connect ors for the foll owing;

1.44 Are intact and have no signs of damage, to include but not limited to bare wires,

chaffing, cuts and loose wiring.

1.45 If there are any signs of damage, the damage item MUST be taken out of service

until the damage has been repaired by an electrically competent person.

1.46 All trailing cables should be routed so as not to cause any kind of trip hazard.

1.47 NEVER work on or near electricity with wet hands, wet clothing and wet gloves.

5

1.50 Batteries (where present).

1.51 Batteries present a risk if they become damaged by the possible leaking of

electrolyte. This electrolyte is an acid and can cause serious burn injuries. Care
should be taken when working on or near them. NOTE the electrolyte may be in
a liquid or gel form.

1.52 Should you come in to contact with electrolyte you should;

1.53 Remove all clothing contaminated with electrolyte. If you cannot remove then

saturate them in water.

1.54 Get medical assistance as soon as possible. You must advise the medical staff of

the type of acid.

1.55 Lead/acid battery = dilute sulphuric acid.

1.56 Nickel/cadmium = potassium hydroxide alkali electrolyte.

1.57 Use fresh running water to wash off excess electrolyte, continue this until medical

assistance arrives. Make sure that you do not was the electrolyte to another part of
your body or face.

1.58 If electrolyte comes in to contact with Eyes the electrolyte needs to be immediately

washed away with large amounts of water. Make sure that you do not wash the
electrolyte to another p ar t of your fac e or body.

1.59 Gasses from charging batteries are highly flammable and great care should be taken

to charge in well ventilated areas.

1.59.1 There is an explosion risk if the battery terminals are short circuited, when

connecting/disconnecting ALWAYS exercise great care so that the terminals or
battery leads are NOT allowed to touch and cause a spark. ALWAYS use suitable
insulated tools.

1.60 Vibrations (where applicable).

1.61 Prolonged use of hand held (operated) machines will cause the user to feel the

effects of/from vibrations. These vibrations can lead to white finger (Raynaud’s
phenomenon) or carpal tunnel syndrome. This condition reduces the ability of the
hand to feel and regulate temperature, causing numbness and heat sensations and
may cause never damage and circulatory tissue death.

1.62 Not all factors that lead to white finger disease are known, but cold weather, smoking

and other diseases that affect blood vessels and blood circulation as well as large
and long-lasting impact of shocks are considered factors in the formation of white
finger. Note the following to reduce the risk of white finger and carpal tunnel
syndrome;

1.63 Wear gloves and keep your hands warm.

1.64 Take regular breaks.

1.65 All of the above precautions may help reduce the risk of white finger disease but not

rule out the carpal tunnel syndrome. Long-term and regular users are therefore
recommended to observe the condition of yo ur hands and fi ng er s. S eek me di cal
attention immediately if any of the above symptoms should occur.

1.70 Noise (where applicable).

6

1.71 The operating noise of the machi ne c an da ma g e y our heari ng . Wear hearing

protection such as earplugs or ear defenders to protect your hearing. Long-term
and regular users are advised to have hearing checked regularly. Be especially
vigilant and cautious when hearing ear protection because your ability to hear alarm
warnings will be reduced.

1.72 Noise emissions for this equipment is unavoidable. Carry out noisy work at approved

times and for certain periods. Limit the working time to a minimum. For your personal
protection and protection of people working nearby it is also advisable for them to
wear hearing protection.

1.73 See CERTIFICATE of CONFORMITY section for Outdoor Noise declaration of

conformity.

7

1

Drive Unit

11

Locking Pin

2

Auger Drill Bit Ø 100mm

12

Choke Lever

3

Auger Drill Bit Ø 150mm

13

Air Filter Housing

4

Auger Drill Bit Ø 200mm

14

Spark Plug

5

Handle

15

Fuel Tank

6

Operating Handle

16

Fuel Filler Cap

7

Throttle Trigger

17

Fuel/Oil Mixing Bottle

8

ON / OFF Switch

18

Tool Kit

9

Drive Shaft

19

Recoil Starting Handle

10

Shaft Locking Bolt

20

Primer Bulb

2. PART LOCATIONS

8

3. QUICK START GUIDE

CAUTION

This guide is meant to serve as a quick reference for operating your P1PE Earth

Auger.
We ALWAYS advise reading the manual in full before operation.

CAUTION

For OUTDOOR use ONLY.
Petrol machinery produces Carbon Monoxide - a poisonous, colourless and
odourless gas that can cause serious injury or death. Petrol is highly flammable,
always handle with extreme care and in a well ventilated area.

2.0 Select one of the three auger bits to be fitted.

2.1 Slot the auger shaft (1) over the end of the power unit drive shaft (2).

2.2 Align the hole in the shaft with the holes in the auger bit.

2.3 Pass the shaft locking bolt (3) through the auger and shaft then secure with the

locking pin (4).

(1) Auger Shaft

(3) Locking Bolt

(4) Locking Pin

(2) Drive Shaft

9