Ozito OZWDBG250WA Operation Manual

Wet & Dry
Bench Grinder

200/150mm

Operation Manual
3 Year Replacement Warranty

OZWDBG250WA

CAUTION: Read this operation manual before using this tool.

To view the full range visit: www.ozito.com.au

0409

SPECIFICATIONS – MODEL NO. OZWDBG250WA

Input Power: 250W (S2-30min)
Input Voltage: 230-240V ~ 50Hz
No Load Speed: 134/min Wet Sharpening Wheel

2950/min Dry Grinding Wheel

IP Degree: IP24
Wet/Dry Wheel Diameter: 200/150mm
Wet/Dry Wheel Thickness: 40/20mm
Wet/Dry Wheel Bore Size: 20/12.7mm
Wet/Dry Wheel Grit: 80/36
Protection Class: 1 (earthed appliance)

Features: Induction Motor

Wet & Dry Wheels
Adjustable Tool rests
Mounting Holes
Dust sealed Switch

The Wet & Dry Bench Grinder has been designed to comply with the following
Australian/New Zealand Standards and any other applicable standards referenced
therein:

AS/NZS3100: 2002+A1:2003+A2:2004+A3:2005 Approval and test specification –
general requirements for electrical equipment

15

14

13

1. Eye Shield Bracket

2. Eye Shield

3. Dry Grinding Wheel

4. Wheel Guard

5. Tool Rest

2

1

12

11

10

6. Tool Rest Bar

7. Wheel Guar
ool Rest Adjusting Knob

T

8.

d Cover

9. Mounting Hole

10. Rubber foot

8

9

11. On/Off switch

12. Motor Housing
ater T

13. W
ater Trough

14. W
et Sharpening Wheel

15. W

2

3

4

5

6

7

ough Plug

r

TABLE OF CONTENTS

SPECIFICATIONS…….……………………………………

TABLE OF CONTENTS…………………………………...

INTRODUCTION………………………………………….

SAFETY INSTRUCTIONS………………………………...

OPERATION ………………………………………………

MAINTENANCE …………….……………………………

CONTENTS ……………………………………………….

WARRANTY………………………………………………..

Page 2

Page 3

Page 4

Page 4

Page 8

Page 10

Page 11

Page 12

3

INTRODUCTION

Congratulations on purchasing an Ozito Wet & Dry
Bench Grinder. We aim to provide quality tools at an
affordable price. We hope you will enjoy using this tool
for many years.

The Ozito Wet & Dry Bench Grinder OZWDBG250WA
has been designed to easily cope with all sharpening
and grinding requirements. This tool is intended for
DIY use only.

SAFETY INSTRUCTIONS

Warning! When using mains-powered tools, basic safety precautions,

!

!

including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.

Read the whole manual carefully and make sure you know how to switch the
tool off, in an emergency, before operating the tool.

Save these instructions and other documents supplied with this tool for
future reference.

ELECTRICAL SAFETY

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric shock.

4