Ozito OZTCS600WA Instruction Manual
Tile Cutting Saw
600W
Instruction Manual
3 Year Replacement Warranty
OZTCS600WA
WARNING! Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
To view the full range visit: www.ozito.com.au
0212
!!
Motor: 600W (S1=500W S2-20min=600W)
Input: 230V ~ 50Hz
No load speed: 2950 /min
Wheels: 180mm x 22.2mm
Max. cutting depth: 33mm
Mitre angle: 0 - 45º
Table dimensions: 330mm x 360mm
Protection Class: 1 (Earthed appliance)
Weight: 9.5kg
1. On/off Switch
2. Mounting hole
3. Cooling water reservoir
4. Table top
5. Safety guard
6. Riving knife
7. Cutting blade
8. Parallel guide
9. Allen key
10. Shaft wrench
11. Cutting Blade wrench
12. 45° Cutting guide
SPECIFICATIONS - MODEL NO. OZTCS600WA
2
6
78
5
4
3
2
1
2
10
9
11
12
KNOW YOUR PRODUCT
TABLE OF CONTENTS
3
SPECIFICATIONS…………………………………………
KNOW YOUR PRODUCT………………………………..
INTRODUCTION………………………………………...
SAFETY INSTRUCTIONS…………………………………
ADDITIONAL SAFETY RULES FOR CUTTING SAW…
OPERATION ……………………………………………..
MAINTENANCE …………….…………………………..
SPARE PARTS…………………………………………….
CONTENTS ……………………………………………...
WARRANTY………………………………………………
Page 2
Page 2
Page 4
Page 5
Page 7
Page 7
Page 10
Page 10
Page 11
Page 12
4
Congratulations on purchasing an Ozito Tile Cutting Saw. We
aim to provide quality tools at an affordable price. We hope
you will enjoy using this tool for many years.
Your Tile Cutting Saw OZTCS600WA has been designed for
cutting ceramic and clay paving and wall tiles, slate, marble,
granite, clay and terracotta wall and floor tiles. It is intended
for DIY use only.
Warning! When using mains-powered tools, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.
Read the whole manual carefully and make sure you know how to switch the tool
off, in an emergency, before operating the tool.
Save these instructions and other documents supplied with this machine for
future reference.
The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.
The tool is earthed in accordance with AS/NZS 60335:2002
Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealeand.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric shock.
It is recommended that the extension lead is a maximum of 25m in length. Do Not
use multiple extension leads.
INTRODUCTION
ELECTRICAL SAFETY
!
!
!!
Loading...