Ozito OZPPL280WA Operating Instructions Manual
PALM PLANER
280W MODEL NO. OZPPL280WA
www.ozito.com.au
To view our full range visit
OPERATING INSTRUCTIONS
1. Depth of cut adjustment knob
2. Lock off button
3. On/Off Switch
4. Rubber Palm Grip
5. Rear Shoe (Not shown)
6. Drive belt cover
7. Planer drum (Not shown)
8. Adjustable front shoe
9. Material extractor port
10. Spanner
11. Chip Collection Bag
Motor size: 280W
Input: 230 – 240V ~ 50Hz
No load speed: 18000 /min
Planing width: 50 mm
Planing depth: 0 – 0.6 mm
Blade type: 50 mm TCT reversible slither blades
Weight: 1.4kg
Features: Ergonomic design
Material collection bag
Variable depth of cut
Soft grip handle
Palm grip design
This Palm Planer has been designed to comply with the following Australian/New Zealand
Standards and any other applicable standards referenced therein:
AS/NZS 60745-1 Hand held motor operated electric tools - Safety
general requirements.
AS/NZS 60745-2.14 Hand held motor operated electric tools.
Particular requirements for planers
8
1
3
5
7
4
6
9
2
11
10
2
SPECIFICATIONS – MODEL NO. OZPPL280WA
3
TABLE OF CONTENTS
SPECIFICATIONS…………………………………………
TABLE OF CONTENTS…………………………………..
INTRODUCTION………………………………………...
SAFETY INSTRUCTIONS………………………………..
OPERATION ……………………………………………..
MAINTENANCE …………….…………………………..
CONTENTS ……………………………………………...
WARRANTY………………………………………………
Page 2
Page 3
Page 4
Page 4
Page 8
Page 10
Page 11
Page 12
INTRODUCTION
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
4
Congratulations on purchasing an Ozito Palm Planer.
We aim to provide quality tools at an affordable price.
We hope you will enjoy using this tool for many years.
Your Ozito Palm Planer OZPPL280WA has been designed
for planing timber and is intended for DIY use only.
Warning! When using mains-powered equipment, basic safety
precautions, including the following, should always be
followed to reduce risk of fire, electric shock, personal injury
and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for
future reference.
The electric motor has been designed for 230V and 240V only. Always
check that the power supply corresponds to the voltage on the rating plate.
Note: The supply of 230V and 240V on Ozito tools are interchangeable
for Australia and New Zealand.
If the supply cord is damaged, it must be replaced by an electrician or a
power tool repairer in order to avoid a hazard.
Note: Double insulation does not take the place of normal safety
precautions when operating this tool. The insulation system is for added
protection against injury resulting from a possible electrical insulation
failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of
this tool. Before use, inspect the extension lead for signs of damage, wear
and ageing. Replace the extension lead if damaged or defective.
When using an extension lead on a r
eel, always unwind the lead
completely. Use of an extension lead not suitable for the power input of
the tool or which is damaged or defective may result in a risk of fire
and/or electric shock.
It is recommended that the extension lead is a maximum of 25m in
length. Do Not use multiple extension leads.
!
!
Loading...