Ozito OZOS300WA Operation Manual

Orbital Sander

1

/2 Sheet 300W

Operation Manual
3 Year Replacement Warranty

OZOS300WA

To view the full range visit: www.ozito.com.au

1108

Input: 240V ~ 50Hz
Motor size: 300W
No load speed: 12,000 /min
Net Weight: 2.15kg
Pad Size: 225 x 115mm

Sandpaper Size: 230 x 115mm (

1

/2 Sheet)

Features Ergonomic Soft Grip

Flush Sanding on 3 Sides
Lock-on Switch
Dust Bag

This Orbital Sander has been designed to comply with the following Australian/
New Zealand Standards and any other applicable standards referenced therein:

AS/NZS 60745-2-4 Hand held motor operated electric tools. Particular
requirements for sanders and polishers other than disc type.

AS/NZS 60745-1 Hand held motor operated electric tools -Safety
general requirements

1. Front Handle

2. Rear Handle

3. Lock-on Button

4. On/Off Switch

5. Dust Bag

6. Paper Clamp

7. Base Plate

8. Rubber Pad

4

2

1

6

8

3

7

5

SPECIFICATIONS - MODEL NO. OZOS300WA

2

TABLE OF CONTENTS

3

SPECIFICATIONS…………………………………………

TABLE OF CONTENTS…………………………………..

INTRODUCTION………………………………………...

SAFETY INSTRUCTIONS………………………………..

GENERAL SAFETY……………………………………….

TOOL OPERATION ……………………………………..

MAINTENANCE …………….…………………………..

CONTENTS ……………………………………………...

WARRANTY………………………………………………

Page 2

Page 3

Page 4

Page 4

Page 5

Page 8

Page 10

Page 11

Page 12

Congratulations on purchasing an Ozito Orbital Sander.
We aim to provide quality tools at an affordable price.
We hope you will enjoy using this tool for many years.

Your Orbital Sander OZOS300WA has been designed
for the easy sanding of timber. It is intended for DIY
use only.

Warning! When using mains-powered tools, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.

Read the whole manual carefully and make sure you know how to switch the tool
off, in an emergency, before operating the tool.

Save these instructions and other documents supplied with this machine for
future reference.

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS 60745; therefore no earth
wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a power
tool repairer in order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions
when operating this tool. The insulation system is for added protection against
injury resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.

Before use, inspect the extension lead for signs of damage, wear and ageing.

Replace the extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead completely. Use of an
extension lead not suitable for the power input of the tool or which is damaged or
defective may result in a risk of fire and electric shock.

INTRODUCTION

4

!

!

SAFETY INSTRUCTIONS

ELECTRICAL SAFETY