Ozito OZHT460A Operation Manual

Hedge
Trimmer

460mm - 520Watt

Operation Manual
2 Year Replacement Warranty

OZHT460A

To view the full range visit: www.ozito.com.au

0309

CAUTION! Read the operation manual before use.

Input: 230 - 240V ~ 50Hz
No load speed: 1,600/min
Blade length: 460mm
Max. cutting capacity: 16mm

Features: Dual action cutting blades

Dual handed safety switch
Blade brake
Cord retainer
Safety guard

1. Rear handle

2. Trigger switch

3. Front handle/trigger

4. Blade support rail

5. Dual action cutting blades

6. Cord retainer

6

1

3

2

SPECIFICATIONS - MODEL NO. OZHT460A

5

2

4

3

TABLE OF CONTENTS

SPECIFICATIONS …………………………………………

TABLE OF CONTENTS…………………………………...

INTRODUCTION…………………………………………

SAFETY INSTRUCTIONS………………………………..

OPERATION ………………………………………………

MAINTENANCE …………….……………………………

CONTENTS ………………………………………………

WARRANTY……………………………………………….

Page 2

Page 3

Page 4

Page 4

Page 7

Page 9

Page 10

Page 11

INTRODUCTION

SAFETY INSTRUCTIONS

4

Congratulations on purchasing an Ozito Hedge
Trimmer. We aim to provide quality tools at an
affordable price. We hope you will enjoy using this tool
for many years.

Your Hedge Trimmer OZHT460A has been designed for
trimming light foliage and is intended for DIY use only.

Warning! When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.

Read and understand the manual prior to operating this tool.

Save these instructions and other documents supplied with this tool for
future reference.

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS 3100: 2002;
therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a power
tool repairer in order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective. When using an extension lead
on a reel, always unwind the lead completely. Use of an extension lead not suitable
for the power input of the tool or which is damaged or defective may r

esult in a risk

of fire and electric shock.

ELECTRICAL SAFETY