Ozito OZHD1100WA Operation Manual

Hammer Drill

1100W

Operation Manual
3 Year Replacement Warranty

OZHD1100WA

To view the entire range visit: www.ozito.com.au

0209

SPECIFICATIONS – MODEL NO. OZHD1100WA

Motor Size: 1100W
Input: 230V ~ 50 Hz
Chuck Size: 13mm (1/2”) Keyed
No Load Speed: 0 – 2,800 /min
Impact rate: 44,800 bpm
Net Weight: 2.5kg
Drilling Capacity: Timber 25mm

Steel 13mm
Masonry 13mm

Features: Heavy Duty Gear Box

Brush Wear Indicator
Keyed Chuck
360º Side Handle
Depth Rod

2

10

1

5

6

9

8

1. Keyed Chuck

2. Hammer selector

3. Brush wear indicator

4. Variable speed switch

5. Forward/reverse lever

2

6. Speed selection dial

7. Lock-on button

8. Side handle

9. Chuck key

10. Depth rod

11. Chuck key holder

3

4

7

11

TABLE OF CONTENTS

SPECIFICATIONS - MODEL NO. OZHD1100WA …….

TABLE OF CONTENTS…………………………………...

INTRODUCTION………………………………………….

SAFETY INSTRUCTIONS………………………………...

OPERATION ………………………………………………

MAINTENANCE …………….……………………………

CONTENTS ……………………………………………….

WARRANTY………………………………………………..

Page 2

Page 3

Page 4

Page 4

Page 7

Page 9

Page 10

Page 11

3

INTRODUCTION

Congratulations on purchasing an Ozito Hammer Drill.
We aim to provide quality tools at an affordable price.
We hope you will enjoy using this tool for many years.

The Ozito Hammer Drill OZHD1100WA has been
designed for drilling timber, steel and masonry. This
tool is intended for DIY use only.

SAFETY INSTRUCTIONS

Warning! When using mains-powered tools, basic safety precautions,

!

!

including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.

Read the whole manual carefully and make sure you know how to switch the tool
off, in an emergency, before operating the tool.

Save these instructions and other documents supplied with this tool for future reference.

ELECTRICAL SAFETY

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS60745; therefore
no earth wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a
power tool repairer in order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric shock.

4