Ozito OZDS280WA Operation Manual

Detail Sander

280 Watt

Operation Manual
3 Year Replacement Warranty

OZDS280WA

To view the full range visit: www.ozito.com.au

0409

Motor size: 280W
Input: 230 - 240V ~ 50Hz
No load speed: 6,000 - 10,000/min
Weight: 1.4kg

Features: Ergonomic design

Dust Extraction Adaptor
Hook & loop
Soft grip handle

This Detail Sander has been designed to comply with the following Australian/ New
Zealand Standards and any other applicable standards referenced therein:

AS/NZS 60745-1 Hand held motor operated electric tools -

Safety general requirements

AS/NZS 60745-2-4 Hand held motor operated electric tools.

Particular requirements for sanders and polishers
other than disc type.

SPECIFICATIONS - MODEL NO. OZDS280WA

2

1

2

3

4

6

1. ON/OFF switch

2. Variable Speed Dial

3. Hook &loop base plate

4. Sanding sheet

5. Dust extraction port

6. Dust extraction adaptor

5

3

TABLE OF CONTENTS

SPECIFICATIONS …………………………………………

TABLE OF CONTENTS…………………………………...

INTRODUCTION………………………………………….

SAFETY INSTRUCTIONS………………………………...

TOOL OPERATION………………………………………

MAINTENANCE …………….……………………………

CONTENTS ……………………………………………….

WARRANTY………………………………………………..

Page 2

Page 3

Page 4

Page 5

Page 8

Page 10

Page 11

Page 12

INTRODUCTION

ELECTRICAL SAFETY

4

Congratulations on purchasing an Ozito Detail Sander. We
aim to provide quality tools at an affordable price. We
hope you will enjoy using this tool for many years.

Your Ozito Detail Sander OZDS280WA has been
designed for sanding timber and is intended for DIY
use only.

The electric motor has been designed for 230V and 240V only. Always
power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable
for Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS60745;
therefore no earth wire is required.

Note: Double insulation does not take the place of normal safety
precautions when operating this tool. The insulation system is for added
protection against injury resulting from a possible electrical insulation
failure within the tool.

If the supply cord is damaged, it must be replaced by an electrician or a
power tool repairer in order to avoid a hazard.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of
this tool. Before use, inspect the extension lead for signs of damage, wear
and ageing. Replace the extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead
completely. Use of an extension lead not suitable for the power input of
the tool or which is damaged or defective may result in a risk of fire
and/or electric shock.

It is recommended that the extension lead is a maximum of 25m in
length. Do Not use multiple extension leads.