Ozito OZBP110WA Operation Manual

Buffer Polisher

110 Watt

Operation Manual
3 Year Replacement Warranty

OZBP110WA

To view the full range visit: www.ozito.com.au

0409

1. On/Off switch

2. Cordset

3. Foam pad

4. Adjustable handle knobs

5. Adjustable handle

6. Motor housing

7. Motor cover

8. Applicator bonnet

9. Polishing bonnet

Motor size: 110W
Input: 240V ~ 50Hz
No load speed: 3200 /min
Buffing pad diameter: 240mm (10")
Orbit diameter: 12.7mm (1/2")
Weight: 3.65kg

Features: Random orbit operation

Individually adjustable handles
Compact design
Comfortable, ergonomic handles
Reusable buffing & polishing bonnets

This Polisher has been designed to comply with the following Australian/New Zealand
Standards and any other applicable standards referenced therein:

AS/NZS60745.2.4:2003 Hand held motor operated electric tools - Safety

general requirements.
Part 2.4: Particular requirements for polishers

3

7

1

5

5

8

2

SPECIFICATIONS – MODEL NO. OZBP110WA

9

2

4

6

4

3

TABLE OF CONTENTS

SPECIFICATIONS…………………………………………

TABLE OF CONTENTS…………………………………..

INTRODUCTION………………………………………...

SAFETY INSTRUCTIONS………………………………..

OPERATION ……………………………………………..

MAINTENANCE …………….…………………………..

CONTENTS ……………………………………………...

WARRANTY………………………………………………

Page 2

Page 3

Page 4

Page 4

Page 9

Page 10

Page 11

Page 12

INTRODUCTION

SAFETY INSTRUCTIONS

ELECTRICAL SAFETY

4

Congratulations on purchasing an Ozito Buffer Polisher.
We aim to provide quality tools at an affordable price.
We hope you will enjoy using this tool for many years.

Your Ozito Buffer Polisher OZBP110WA has been
designed for polishing cars, boats and solid surfaces like
granite, marble and stainless steel. It is intended for DIY
use only.

Warning! When using mains-powered equipment, basic safety
precautions, including the following, should always be followed to reduce
risk of fire, electric shock, personal injury and material damage.

Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for

future reference.

The electric motor has been designed for 230V and 240V only. Always check that the
power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

If the supply cord is damaged, it must be replaced by an electrician or a power
tool repairer in order to avoid a hazard.

This tool is double insulated in accordance with AS/NZS60745; therefore no
earth wire is required.

Note: Double insulation does not take the place of normal safety precautions
when operating this tool. The insulation system is for added protection against
injury resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective.

When using an extension lead on a reel, always unwind the lead completely. Use of
an extension lead not suitable for the power input of the tool or which is damaged
or defective may result in a risk of fir

e and/or electric shock.

It is recommended that the extension lead is a maximum of 25m in length. Do Not
use multiple extension leads.

!

!