Ozito OZBLV2400WA Operation Manual
Electric
Blower Vac
2400 Watt
Operation Manual
2 Year Replacement Warranty
OZBLV2400WA
To view the full range visit: www.ozito.com.au
1208
Motor: 2400 watt
Input: 230 – 240V ~ 50Hz
No load speed: 13,000 / 15,000/min
Air speed: 160 / 270km/hour
Air volume: 12m3/min
Noise level: 100dB
Mulching ratio: 10:1
Collection bag: 40 Litres
Weight: 5.3kg
Features: Direction tube
Shoulder strap
Guide rollers
1. Lower blower tube
2. Upper blower tube
3. Main handle
4. On/off switch
5. Hook for shoulder strap
6. Secondary handle
7. Mode selecting lever
8. Collection bag
9. Guide rollers
9
5
2
SPECIFICATIONS - MODEL NO. OZBLV2400WA
7
6
4
3
2
1
8
3
TABLE OF CONTENTS
SPECIFICATIONS…………….……………………………
TABLE OF CONTENTS…………………………………...
INTRODUCTION………………………………………….
SAFETY INSTRUCTIONS………………………………....
GENERAL…………………………………………………..
ADDITIONAL SAFETY RULES FOR BLOWER VACS…..
ASSEMBLY…………………………………………………
OPERATION…………………………………………………
MAINTENANCE …………….……………………………
DESCRIPTION OF SYMBOLS……………………………
CONTENTS ……………………………………………….
WARRANTY……………………………………………….
Page 2
Page 3
Page 4
Page 4
Page 5
Page 7
Page 8
Page 8
Page 10
Page 10
Page 11
Page 12
INTRODUCTION
SAFETY INSTRUCTIONS
4
Congratulations on purchasing the Ozito Electric
Blower Vac. We aim to provide quality tools at an
affordable price. We hope you will enjoy using this tool
for many years.
The Blower Vac OZBLV2400WA has been designed for
blowing and vacuuming leaves, grass clippings and other
debris from courtyards, driveways, decks, car-parks,
footpaths etc. This product is intended for DIY use only.
Warning! When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for
future reference.
The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.
Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.
This tool is double insulated in accordance with AS/NZS 3100: 2002;
therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by an electrician or a power
tool repairer in order to avoid a hazard.
Note: Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective. When using an extension lead
on a reel, always unwind the lead completely. Use of an extension lead not suitable
for the power input of the tool or which is damaged or defective may result in a risk
of fire and electric shock.
ELECTRICAL SAFETY
Loading...