Ozito OZBL1800WA Operation Manual

Electric
Blower

1800 Watt

Operation Manual
2 Year Replacement Warranty

OZBL1800WA

To view the full range visit: www.ozito.com.au

0212

Motor: 1800 watt
Input: 220 – 240V ~ 50Hz
No load speed: 17,000/min
Air volume: 12,360 CF/hour
Air speed: 317km/hour
Noise level: 102dB
Weight: 2.9kg

Features: Direction nozzle

Rocker switch
Extension lead retaining loop

1. Rocker switch

2. Large ergonomic handle

3. Air intake vent

4. Cord retaining loop

5. Direction nozzles

1

2

2

SPECIFICATIONS - MODEL NO. OZBL1800WA

4

5

3

3

TABLE OF CONTENTS

SPECIFICATIONS …………………………………………

TABLE OF CONTENTS…………………………………...

INTRODUCTION…………………………………………

SAFETY INSTRUCTIONS………………………………...

GENERAL………………………………………………….

ASSEMBLY…………………………………………………

OPERATION ………………………………………………

MAINTENANCE …………….……………………………

DESCRIPTION OF SYMBOLS…………………………...

CONTENTS ………………………………………………

WARRANTY……………………………………………….

Page 2

Page 3

Page 4

Page 4

Page 5

Page 8

Page 8

Page 9

Page 9

Page 10

Page 11

INTRODUCTION

SAFETY INSTRUCTIONS

4

Congratulations on purchasing the Ozito Electric
Blower. We aim to provide quality tools at an
affordable price. We hope you will enjoy using this tool
for many years.

The Blower OZBL1800WA has been designed for
blowing leaves, grass clippings and other debris from
courtyards, driveways, decks, car-parks, footpaths etc.
This product is intended for DIY use only.

Warning! When using mains-powered equipment, basic safety precautions,
including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.

Read and understand the manual prior to operating this tool.

Save these instructions and other documents supplied with this tool for
future reference.

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS 3100: 2002;
therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a power
tool repairer in order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective. When using an extension lead
on a reel, always unwind the lead completely. Use of an extension lead not suitable
for the power input of the tool or which is damaged or defective may result in a risk
of fire and electric shock.

ELECTRICAL SAFETY