Ozito NSG-5000 Instruction Manual

BRAD NAILER
& STAPLER

15-30MM

INSTRUCTION MANUAL

SPECIFICATIONS

Input: 230-240V ~ 50Hz
Rated Power: 50W
Impact Rate: 20 /min
Magazine Capacity: 50 Nails
Nail Type: C1 Brad
Nail Length: 15-30mm
Staple Type: Narrow Crown
Staple Length: 15-25mm
Weight: 1.6kg

NSG-5000

WHAT’S IN THE BOX

Brad Nailer & Stapler

Nails x 500

Staples x 500

ozito.com.au

Hex Key

ONLINE MANUAL

Scan this QR Code with your
mobile device to take you to
the online manual.

7 20mm Nails x 500

8 20mm Staples x 500

9 Hex Key

ACCESSORIES

1 Safety Striker Pin

2 On/off Trigger

3 Handle

4 Magazine

5 Power Switch

6 Variable Depth Adjustment Dial

2 IN 1 BRAD NAILER AND STAPLER

KNOW YOUR PRODUCT

1. LOADING STAPLES

1. Squeeze the magazine latch and pull the magazine away from
the tool.

3. Close the magazine, ensuring it clicks into place.

2. Slide a row of staples over the the middle of the magazine so that
the staples straddle the inner chamber.

SETUP & PREPARATION

Ensure the tool is disconnected from the power supply
before performing any of the following operations.

2. LOADING NAILS 3. CONTROLS

OPERATION

The tool is recommended for use with a residual current
device with a rated residual current of 30mA or less.

1. Squeeze the magazine latch and pull the magazine away from the
tool.

3. Close the magazine, ensuring it clicks into place.

2. Insert a row of nails into the second track of the magazine. The

nails should be ush against the inner chamber.

To re the nail and

staple gun, squeeze
the on/off trigger.

1. To supply the tool with

power, ick the power

switch to the “I” position.

Power Switch

On/off Trigger

Variable Depth Adjustment Dial

2. To turn off, ick the power

switch to the “0” position.

The variable depth adjustment dial allows you to control the depth

at which the nail gun res a nail or staple.

To increase depth,
turn the variable depth
adjustment dial toward the
“+” symbol.

To decrease depth, turn
the dial to the “-” symbol.

Note: IF THE MAGAZINE WILL NOT CLOSE, THE

MAGAZINE MAY BE OVER CAPACITY. REMOVE SOME
NAILS/ STAPLES THEN TRY TO CLOSE AGAIN.

1. To nd the correct depth
setting, re a nail into a

scrap piece of material.

2. Adjust the dial and re

another nail. Repeat until

the nail is driven ush with

the work surface