Please read the entire instruction manual before using the product and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
• The product should only be connected to a 220-240V AC, 50Hz
electrical outlet.
• Never leave the product unattended whilst it is switched on.
• If you have to leave the product unattended, even for a short
while, always switch it off.
• Keep the product out of children’s reach and do not allow children
to use it.
• The product is only intended for normal domestic use and only in
the manner described in this instruction manual.
• Inspect the mains lead regularly. Never use the product if the
mains lead or plug has been damaged in any way.
• Do not place the mains lead on or near any hot surface.
• Do not touch the product if your hands are moist or wet.
• Never move the product by pulling on the lead.
• Keep furniture, curtains and other flammable material at least 1
metre away from the product.
• Do not run the power cord under carpets, rugs etc. or anywhere
where is may present a trip hazard.
• Do not use this heater in bathrooms.
• Never place the cable directly against the heater or close to a hot
air outlet.
• Do not touch the heater the heater during use as it will get very
hot and could cause injury.
• The heater must not be located immediately below or next to a
mains power supply.
• Never cover the heater in any way.
• Do not move the heater whilst it is use.
• Never use the heater in areas where explosive gasses or liquids
are stored.
• The heater should be used on a stable, heat-resistant surface.
• This product is not intended for use by persons (including
children) with reduces physical, mental and sensory capacities, or
lack of experience and knowledge, unless they have been given
supervision or instructions concerning the use of the product by
persons responsible for their safety.
• Do no discard of any packaging until you have checked that you
have all of the parts and fittings required.
• If the product is damaged or has any defects, please contact
cservice@oypla.com