Page 1
Aluminium Cold Frame
User Manual
USER MANUAL Model No: 3813
Page 2
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 3813
• Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
• This product is intended for outdoor use only.
• This product is not a toy, and is only to be used for its designated purpose.
• Clean only with a damp cloth. Do not use strong industrial cleaning substances.
• To achieve best results, choose a place in maximum light.
• In order to avoid damage to the product, do not place under overhanging trees.
• Avoid placing in areas that are exposed to strong winds.
• Do not carry out alterations or modifications to this product.
• This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
• Keep fingers, loose clothing, and hair away when assembling the product. Pinch
points can cause personal injury.
• Do not discard any of the packaging until you have checked that you have all of the
parts and fittings required.
• Use the correct fixings as indicated. Do not tighten any of the nuts until the unit is
completely assembled, then finish by tightening all nuts. All nuts must be tightened
before use.
• Only use this product on stable, level and dry ground.
• If the product is damaged or has any defects, please contact [email protected]
Page 3
USER MANUAL Model No: 3813
Operating Instructions
Parts List:
If you are missing any of the below parts please contact [email protected]
Please be aware that you will be referring to this parts list throughout the assembly
Page 4
1. Attach the side sheets to the front and rear sheets by sliding the connectors together as shown.
2. Attach the corner braces to the bottom of the assembled frame.
3. Attach the corner connectors to the top of the assembled frame.
4. Attach the lid by sliding the connectors together along the top of the rear sheet.
5. Secure the cold frame into the ground at each corner using the ground stakes.
Assembly Instructions
Please retain a copy of all instructions for future
consultation.
USER MANUAL Model No: 3813
Loading...