Ovente BLH1012 Instruction Manual

BLENDER MAINTENANCE

Voltage

Frequency

Wattage

120 VAC

60 Hz

400 W

8

ovente.com

WARNING: Always unplug the product from the electrical outlet before assembling, disassembling, or cleaning it.

 If the product’s motor does not run freely while blending ingredients, perform one or more of the

following steps, as necessary:

a) Press the OFF Button and add water to the ingredients
b) Press the PULSE Button for a few minutes and the motor blends freely
c) Press the OFF Button, unplug the blender from the electrical outlet and use a rubber spatula to clear the

sides of the blender jar and push the ingredients toward the Blades (rubber spatula not included).

d) Reduce the amount of ingredients inside of the blender jar

 Clean the product immediately after each use. Before cleaning and putting your hands and fingers

inside of the blender jar, remove the blender jar from the motor housing and the plastic lid, blades and
spin base from the plastic blender jar.

 Use a small toothbrush (not included) to remove particles of food lodged underneath the blades.
 Clean the exterior surface of the motor housing by wiping it with a soft, damp cloth.
 Do not use abrasive cleaners or scouring pads to clean the product.
 To clean the blender jar, add ¼ teaspoon of liquid soap to the blender jar and fill with warm water.

Place the blender jar on the motor housing and press the PULSE Button several times for a few seconds.
Remove the blender jar from the motor housing and rinse the blender jar underneath running water.

CAUTION: Do not place the blender jar and the plastic lid into a dishwasher or extremely hot water.

 Dry all product parts thoroughly before storing.
 Store the product in a clean, dry place with the plastic lid removed from the blender jar.

ELECTRICAL REQUIREMENTS

Professional Multi-Speed Blender

ovente.com

BLH1012 Series

Before using please read the instruction manual and keep it for future use.

IMPORTANT SAFEGUARDS

2

ovente.com

When using blender, basic safety precautions should always be followed, including the following：

Signal Word Definitions

DANGER – Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury.

Usage of this signal word is limited to the most extreme situations.

WARNING – Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury.

CAUTION – Indicates a potentially hazardous situation, which, if not avoided, may result in minor/moderate injury or

product/property damage. It also alerts against unsafe practices.

READ ALL INSTRUCTIONS BEFORE USE.

WARNING—To avoid the risk of electrical shock, always make sure the product is unplugged from the electrical

outlet before assembling, disassembling, relocating, servicing, or cleaning it.

WARNING-To reduce the risk of fire, electric shock, or serious personal injury

 To protect against risk of electrical shock do not put cord, plug, or base in water or other liquid.
 Close supervision is necessary when any appliance is used by or near children. Unplug from outlet

when not in use, before putting on or taking off parts, and before cleaning.

 Avoid contacting moving parts.
 Do not operate any appliance with a damaged cord/plug or after the appliance is dropped or damaged in

any manner.

 Do not plug/unplug the product into/from the electrical outlet with a wet hand.
 The use of any attachments, including canning jars, not recommended by the manufacturer may cause a

risk of injury to persons.

 When blending hot liquids, remove center piece of two-piece cover.

 Do not use outdoor or in a damp area.
 Do not let cord hang over edge of table or counter or touch hot surface including stove, oven, etc
 Keep hands and utensils away from moving blades while processing food to reduce the risk of severe

injury to persons or damage to the food chopper. A scraper may be used but must be used only when
the food chopper is not running (scraper not included).

 Blades are sharp. Handle carefully.
 Do not leave your blender unattended.

 Be certain cover is securely locked in place before operating appliance.