Outdoor GreatRoom Company Sonoma 12 Pergola Manual And Installation Instructions

Sonoma 12 Pergola

Manual and Installation Instructions

Please read these instrucons before removing parts from crate

2

Introduction

Thank you for your purchase from The Outdoor GreatRoom Company. This pergola has been engineered and manufactured in
the USA. This user manual will help make the installation and setup of your new pergola fast and easy. Outdoor GreatRoom
company recommends visiting with your local authority for building codes, restrictions, or requirements for this product. Please
read the manual through before starting the project.

This pergola is made of premium grade kiln dried Douglas Fir. Douglas Fir, if maintained properly, will last a very long time,
similar to life of both Cedar and Redwood. All finished pieces have been stained via submersion to ensure even penetration. It is
recommended that the pergola receive a clear, oil-based stain yearly to maintain the color, minimize warping and prevent rot­ting. Every few years a colored oil based stain should be used to keep the original color.

Important:

 Anchoring Required—Contact your local authority for details
 Read instructions prior to assembly
 Assistance is required and we recommend at least 2 people for installation
 Do not let wood pergolas sit on bare ground. Over time this can cause moisture damage and rotting of wood.
 If you have questions contact the place of purchase

Douglas Fir Lumber may have surface splits. This occurs while the lumber dries and seasons. This characteristic is also known as
“checking” in the lumber industry. These can be upwards of 1/8” running inches to feet in length. These characteristics do not
affect the structural strength and integrity of the product nor does it affect or void the warranty.

Before Beginning, make sure that all components listed on the next page were included with your hardware kit.
Contact your dealer if any parts are missing.

Tools Required

 Corded or Cordless Drill
 Measuring Tape
 Level
 Metric Socket Set
 Rubber Mallet
 Step Ladder
 Hammer Drill*
 Concrete Drill Bit*
 Concrete Anchors*
 Construction grade adhesive (such as PL 400)

*Only Required for anchoring to concrete surfaces.

Disclaimer—The Outdoor GreatRoom Company is not liable for damage caused by weather or misuse

NOTE

Extreme weather including heat, cold, rain, snow and high humid-

ity aect all wood products. Taking proper care of your pergola is
essenal to ensure long-lasng performance and beauty.

90224 Sonoma 12 Pergola REV C 8.16.2016

3

A

Col-

X4

B

Tall Corbel
Post Brace

X2

Included Parts:

I

Canopy Beam, T

J

Arch Beam

X6

Rectangular Mend-

ing Plate

X4

X4

C

Short Corbel Post
Brace

X8

1.25” Wood screw

3” Wood screw

x116

H

Canopy Beam, Le L

G

Canopy Beam, Right L

X2

M10 x160 Hex Bolt (with nut and wash-

ers) x8

M10x 55 Hex Bolt (with nut and washers)

x24

M10 x 90 Hex Bolt (with nut and wash-

er) x28

Arch Mending plate

x8

Foot

x4

K

L M

N

O

P

Q

R

2” Wood screw

x8

S

ALL bolts require washers

x60