Outdoor GreatRoom Company Sonoma Assembly Manual

90230 Sonoma Outdoor Kitchen Pergola REV C 8-20-2018
Sonoma Outdoor Kitchen Pergola
Assembly Instructions
90230 Sonoma Outdoor Kitchen Pergola – REV C 8-20-2018
Introduction
This pergola is made of premium grade kiln dried Douglas Fir. Douglas Fir, if maintained properly, will last a very long time, similar to life of both Cedar and Redwood. All finished pieces have been stained via submersion to ensure even penetration. It is recommended that the pergola receive a clear, oil-based stain yearly to maintain the color, minimize warping and prevent rotting. Every few years a colored oil based stain should be used to keep the original color.
Important:
Anchoring Required—Contact your local authority for details
Read instructions prior to assembly
Assistance is required and we recommend at least 2 people for installation
Do not let wood pergolas sit on bare ground. Over time this can cause moisture damage and rotting of wood.
If you have questions contact the place of purchase.
Douglas Fir Lumber may have minor surface splits. This occurs while the lumber dries and seasons. This characteristic is also known as “checking” in the lumber industry. These can be upwards of 1/8” running inches to feet in length. These characteristics do not affect the structural strength and integrity of the product nor does it affect or void the warranty.
Before Beginning, make sure that all components listed on the next page were included with your hardware kit. Contact your dealer if any parts are missing.
Tools Required
Corded or Cordless Drill
Measuring Tape
Level
Metric Socket Set
Rubber Mallet
Step Ladder
Hammer Drill*
Concrete Drill Bit*
Concrete Anchors*
*Only required for anchoring to concrete surfaces.
DisclaimerThe Outdoor GreatRoom Company is not liable for damage caused by weather or misuse.
90230 Sonoma Outdoor Kitchen Pergola – REV C 8-20-2018
Included Parts:
Column
X2
Purlin (2 Styles)
End Purlin
(cross section)
Center Purlin
(cross section)
X3
X2
Corbel
X4
Header Beam
X2
Arch Beam
Foot
X2
Mending Plate
X12
X4
X54
X4
Loading...
+ 6 hidden pages