Outdoor GS.14 Instruction Manual
CONNECTION
Instructions
Premier Two Burner Stove (GS.14)
IMPORTANT: READ THESE INSTRUCTIONS FOR USE
CAREFULLY. FAMILIARISE YOURSELF WITH THE
APPLIANCE BEFORE CONNECTING IT TO ITS GAS
CONTAINER. KEEP THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
Please Note: This appliance is to be used with a Gas Cylinder with
male 3/8 L.H. BSP Fitting.This High Pressure Regulated appliance
must only be used with the supplied hose and regulator or an Outdoor
Connection genuine spare part (1m hose & regulator assembly -
GHR.01 and 1.5m hose & regulator assembly - GHR.02)
IMPORTANT:
- DO NOT MODIFY THIS APPLIANCE.
- This appliance shall only be used with propane gas (LPG) in a rellable gas cylinder container
certied to AS 2469 – 1999.
- IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPES OF GAS CONTAINERS.
WARNING:
1. ONLY USE IN WELL-VENTILATED AREAS
2. CARBON MONOXIDE HAZARD – USING THIS APPLIANCE IN AN ENCLOSED SPACE MAY CAUSE DEATH.
DO NOT USE IN CARAVANS, TENTS, MARINE CRAFT, CARS, MOBILE HOMES OR SIMILAR LOCATIONS.
3. DO NOT use this appliance if it has damaged or worn seals.
4. DO NOT use this appliance if it is leaking, damaged, or does not operate properly.
5. DO NOT use this stove as a space heater in any way.
6. DO NOT place hands or other body parts over the burners during lighting or during use.
7. DO NOT leave stove unattended whilst in use.
8. DO NOT move stove whilst in use.
9. DO NOT travel with stove connected to cylinder in any capacity.
10. KEEP AWAY FROM FLAMMABLE MATERIALS.
11. A distance of 700mm Overhead and 200mm from the side and 200mm from the rear should be the
minimum distance that anything is kept whilst the appliance is running.
12. Only use the hose assembly supplied with the appliance for direct connection to the cylinder –
DO NOT USE ADAPTORS.
13. Should the hose be damaged only use a replacement hose that is specied for this appliance. The
maximum length that can be used on this appliance is 1500mm.
14. If there is a leak on your appliance (smell of gas), immediately attempt to turn o the cylinder valve.
Remove the appliance to a well ventilated location away from any ignition source. Only check for leaks
using soapy water. DO NOT TRY TO DETECT LEAKS USING A FLAME.
Stove Parts
OPERATING INSTRUCTIONS:
1. Remove any packing material before use.
2.
Ensure that cylinder valve/tap and stove taps are completely turned o.
3. Check that the seals between the appliance and the gas cylinder container are in place and in good
condition before connecting the gas cylinder container.
4. Check that no foreign matter has fallen in under the trivet since/from previous use.
Loading...