OttLite PBWX1047 Installation & Assembly

Page 1
EngliSH Organize LED Desk Lamp
D
B
B
E
C
F
H
J
G
A
120°
Lamp cannot be used in this position
Diagram 3Diagram 1 Diagram 2 Diagram 4
CONGRATULATIONS!
You’ve purchased the finest in natural lighting technology with your new OttLite
PRODUCT REGISTRATION FORM
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing placing lamp body base (A) flat on a steady surface.
2. Connect power adapter input (G) into connector (H) in the rear­bottom of the lamp.
3. Plug the AC adapter (F) into a standard household 120V AC outlet. Note: Only use with the supplied AC adapter to avoid damage or fire.
4. Turn the lamp ON & OFF using power switch (B) located on the front-upper side of shade (D). Power switch (B) is a “touch” switch that controls LED brightness setting.
5. To power LED settings, slightly touch the switch to achieve the following:
• turn lamp “ON” to 1st brightness setting; touch the switch “once”;
• for 2nd brightness setting; touch the switch “two-times”;
• for 3rd brightness setting; touch the switch “three-times”;
• to turn lamp “OFF”; touch the switch “four-times”.
6. To reposition the light, hold base (A) steady and grasp either lamp body (C) or shade (D ) depending on needed adjustment.
7. Refer to diagrams 1, 2, 3, 4 for lamp maximum adjustment
range. NOTE : DO NOT FORCE the shade outside adjustable range indicated, as excessive adjustment may
cause damage.
®
product.
SAFETY WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS
1. Turn off and WAIT UNTIL LAMP HEAD (D) IS COOL before handling.
2. The LED panel (E) might get hot after several hours of continuous use, DO NOT place your hands directly on LED light panel.
3. Never use with an extension cord unless the plug can be fully inserted into the receptacles in the extension cord.
4. Do not alter the plug.
5. The lamp head included with this unit cannot be replaced by
the consumer.
6. INDOOR USE ONLY.
NOTE: The important safety instructions appearing in this instruction sheet are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and care must be used with any electrical product.
CAUTION! IF THE ExTERNaL FLExIbLE CabLE OR CORD OF THIS LUmINaIRE
IS DamagED, IT SHaLL bE ExCLUSIvELY REPLaCED bY THE maNUFaCTURER OR ITS SERvICE agENT OR a SImILaR qUaLIFIED PERSON IN ORDER TO avOID a HazaRD. INDOOR USE ONLY.
CAUTION! THE LIgHT SOURCE OF THIS LUmINaIRE IS NOT REPLaCEabLE;
WHEN THE LIgHT SOURCE REaCHES ITS END OF LIFE THE WHOLE LUmINaIRE SHaLL bE REPLaCED.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that of the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Any change or modification to product not
expressly recognized by OttLite Technologies voids
OttLite’s responsibility for proper function of product.
CAN ICES-005 (B)/NMB-005 (B)
AC/DC ADAPTER
Input: AC 100-240V, 50/60 Hz, 0.8A Max Output: 15V DC, 1.4A with a Male DC Plug
THIS LAMP CONTAINS a 5V-2.1A USB output port (J)
located on the base of the lamp. USB port can charge such items as tablets, smartphones, etc.
Organize LED Desk Lamp
CS59399 CS59399-SHPR Z5FS
INS180457 REV122018
Loading...