Otter Outdoors XT 650 User Manual

Otter Wild Bench Instructions

Hole near end

Inserts in bench

Note: Installing bench before attaching the fish house will make the
installation much easier.

Parts included:

Tools required:
Drill
9/32 drill bit
7/16 wrench and socket and ratchet
½ wrench and socket and ratchet
Phillips screwdriver

1. Layout all parts. Turn bench over so the bottom is facing upward and the hinges are
facing away from you. Place the curved support bar with the two holes near the end on
the bench. On the left side, line up the edge of the seat with the inside edge of the tube.
Place the tube clamp bracket over the bar and attach with the Phillips head machine
screws by threading them into the inserts in the bottom of the bench. Attach brackets in
two places on the support bar.

Line up inside edge of the
tube with the edge of the seat.

Hinge

Tube clamp

Tube clamp

2. Attach the center support brace to the bench tube with the ¼ x 2 bolts, washers, and
nylock nuts.

Nylock nut
and washer

Attach here

Center
support
brace

3. Place the second shorter tube on the bench as shown in the picture below. On the left
side, line up the inside edge of the tube with the outside edge of the bench. Adjust it as
necessary so the holes in the main tube line up with the holes in the center support brace.
Attach with the ¼ x 2 bolts, washers and nylock nuts. Also attach the tube clamp
brackets to the bottom of the bench.

Bolt

Attach tube clamp
brackets here.

Line up inside edge of
tube with the outside
edge of the bench.

Attach here with bolts,
washers and nylock nuts .