Otter Outdoors Fish House Patch Kit User Manual

Fish House and Travel Cover Patch Instructions

1. Cut out a fabric patch piece that is larger than the hole by about an inch on all sides.

Hole in fabric

2. Place patch over hole and mark the perimeter with a marker or pen. Turn patch over
and roughen up the backside with some coarse sandpaper. This will allow the material to
adhere together.

Marking the perimeter. Back of patch roughened up

Patch piece to cover hole.

with sandpaper.

3. Spread a thin layer of adhesive around the hole to be patched. Lay patch over the

cover with sandpaper. Spread a thin layer
of adhesive over the area and apply the
patch.

adhesive and press firmly together. The adhesive is very runny so use it carefully.
Adhesive dries in about 3 minutes and is fully cured in about 15 minutes.

4. If desired another piece may be glued over the hole on the inside. This will increase
the strength of the area and give it a better appearance.

Patched hole from the inside. Roughen the area that the patch will

Completed patch with material on both
the inside and outside.