Otter Outdoors Bench Option User Manual
Otter II Bench Option
Installation and Set-Up Instructions
Parts Identification and Check List:
Sled
1
(Sold Seperately)
Support Bar
3
(Qty 2)
Support Bar
4
Bracket (Qty 2)
Bench
2
(Qty 1)
5/16 Washer
9
(Qty 4)
Locking Pin
5
(Qty 2)
6
Sled Bracket
(Qty 2)
#10 x 3/4
7
Bolt (Qty 8)
Tools Required:
1/2 Box End Wrench
1/2 Socket and Ratchet
Drill
3/8 Bit
Phillips Screwdriver
Installation:
1. Layout all parts.
2. Attach both support bars (Item 3) to the bottom
of the bench (Item 2) with the support brackets
(Item 4). Attach the support brackets using the
#10 x 3/4 bolts (Item 7) into the predrilled holes
in the bench. Ref. Diagram 1.
5/16 x 3/4 Hex
8
Bolt (Qty 4)
Diagram 1
7
4
5/16 NyLock Nut
10
(Qty 4)
3
2
3. Place the bench seat assembly onto the sled and set to desired position.
4. Slide the sled bracket (Item 6) under the bench seat assembly and on top of the sled (Item 1) lip. Mark the holes
to be drilled and drill two 3/8 in. holes.
5. Measure the specified distance (See Note 1) over and attach the second sled bracket (Item 6) by marking the
holes to be drilled and drill two 3/8 in. holes.
6. Attach the sled brackets (Item 6) to the sled (Item 1) using a 5/16 x 3/4 bolt (Item 8), 5/16 NyLock nut (Item 10)
and 5/16 washer (Item 9).
7. Take the bench assembly and place the hinged end of the support bracket (Item 3) into the sled bracket (Item 6).
8. Insert the locking pin (Item 5) and secure the bench assembly to the sled (Item 1).
Diagram 2
3
5
9
10
Note 1:
20 in. ............ Small Sled
27-3/4 in. ......Medium Sled
27-3/4 in. ...... Magnum Sled
42 in. ............ Large Sled
6
See Note 1
1
8
9. Once mounted the bench can open and close to gain access to the inside of the sled.
Diagram 3
Pivot bench assembly
backward to gain
access to the sled.
The bench back
rest flips down.
Bench Option
September, 2003
Otter Outdoors Inc.
411 W Congress St. • Maple Lake, MN 55358
Phone 320-963-6480 • www.otteroutdoors.com
Loading...