OtterBox 1933 User Manual

1933 Series Instruction Sheet

For additional help visit www.otterbox.com or call 888.695.8820

Opening your OtterBox 1933 Case

Step 1

Remove the silicone skin from
the hard shell.

Step 2

Separate the two halves of the case.

Installing Your BlackBerry™ Into The Case

Step 1

For maximum protection align the front of the clear
membrane with the keyboard. It is recommended that
you use the provided installation card and microfiber
cloth at this time to reduce any air bubbles trapped
beneath the clear screen film.

Note: This is an optional step, however the clear
membrane provides added protection to the
keypad and screen.

Step 2

Place the phone into the plastic lid. If you are
not using the clear membrane proceed to step
4, otherwise go to the next step.

Step 3

Remove the clear membrane and insert.

Step 3

Wrap back of clear membrane over your BlackBerry.

Step 4

Snap together the plastic lid and the base.

Step 5

Wrap the silicone skin around the device.
Make sure to locate the retaining slots for the
silicone as shown. Note: If any part is mis-

aligned take apart the case and start over.
Pay close attention to the alignment of
keyboard, screen & case features at every
step of installation.

Cleaning/ Maintenance

Included in the package is an installation card and
microfiber cleaning cloth.

Installation Card: Use the installation card at any
time to smooth out any air bubbles between the clear
membrane and the screen of the BlackBerry.

Cleaning Cloth: Use this microfiber cloth for cleaning
the clear plastic membrane, or screen of the phone.

SM40116A