OT Systems FT800-SSRSA, FT800-SSTLSA, FT800-SSRLSA, FT800-SSR, FT800-SSRL Installation And Operation Manual

All Digital Fiber Optic Manufacturing Specialists

Installation and Operation Manual

FT800 Series

10-bit Digital Series

8-ch Video
Fiber Optic Converter

OT Systems Ltd., 2009

Rev 1.1

Models covered in this manual

Standalone Units

Single-Mode Transmitters

FT800-SSTSA

FT800-SSTLSA

Single-Mode Receivers

FT800-SSRSA

FT800-SSRLSA

Multi-Mode Transmitter

FT800-SMTSA

Multi-Mode Receiver

FT800-SMRSA

FT800 Series Installation & Operation Manual

Card Modules

Single-Mode Transmitters

FT800-SST

FT800-SSTL

Single-Mode Receivers

FT800-SSR

FT800-SSRL

Multi-Mode Transmitter

FT800-SMT

Multi-Mode Receiver

FT800-SMR

Remark:

If the optical connector is FC type, the suffix in the model number will be “-FXX”. Eg.

FT800-FST

www.ot-systems.com 1

FT800 Series Installation & Operation Manual

Table of Contents

(1) SAFETY INSTRUCTIONS....................................................................................... 3

(2) PRODUCT OVERVIEW .......................................................................................... 4

2.1 Introduction ....................................................................................................... 4

2.2 Models selection table ...................................................................................... 5

(3) INSTALLATION ....................................................................................................... 6

3.1 General ............................................................................................................. 6

3.2 Standalone unit installation ............................................................................... 6

3.3 Card module installation ................................... Error! Bookmark not defined.

(4) CABLE CONNECTIONS & SETUP PROCEDURES ............................................... 7

4.1 System cable connections ................................................................................ 7

4.2 Ground connection ........................................................................................... 8

(5) OPERATIONAL GUIDES ........................................................................................ 9

5.1 FT800 Series Transmitter ................................................................................. 9

5.2 FT800 Series Receiver ................................................................................... 10

(6) SPECIFICATIONS ................................................................................................. 11

(7) DRAWINGS ........................................................................................................... 12

(8) WARRANTY INFORMATION ................................................................................ 12

(9) CONTACT INFORMATION ................................................................................... 12

www.ot-systems.com 2

FT800 Series Installation & Operation Manual

(1) Safety Instructions

Please be familiar with all information in this manual prior to installation and

operation.

Note 1: The products described contain a Class 1 laser or LED fiber optic emitter. The following

safety precautions apply.

Warning: Do not disconnect the fiber optic connector while the unit is powered up.

Exposure to Class I invisible optical radiation is possible when the internal fiber optic

connector is disconnected while the unit is powered up.

Caution: Any access to the controls, adjustments, or performing operations, which are

other than those specified may result in hazardous radiation exposure. Permanent eye

damage or other bodily injuries may be resulted from such exposure even for only

seconds.

Note 2: This assembly contains parts sensitive to damage by electrostatic discharge (ESD). ESD

precautionary procedures should be applied in the course of touching, removing or inserting parts

or assemblies.

www.ot-systems.com 3