OT Systems FT200-SMTSA, FT200-SSTLSA, FT200-SMRSA, FT200-SST, FT200-SSTL Installation And Operation Manual
...
All Digital Fiber Optic Manufacturing Specialists
Installation and Operation Manual
FT200 Series
10-bit Digital Series
2-ch Video
Fiber Optic Converter
OT Systems Ltd., 2009
Rev 1.1
FT200 Series Installation & Operation Manual
www.ot-systems.com 1
Models covered in this manual
Standalone Units
Single-Mode Transmitters
FT200-SSTSA
FT200-SSTLSA
Single-Mode Receivers
FT200-SSRSA
FT200-SSRLSA
Multi-Mode Transmitter
FT200-SMTSA
Multi-Mode Receiver
FT200-SMRSA
Card Modules
Single-Mode Transmitters
FT200-SST
FT200-SSTL
Single-Mode Receivers
FT200-SSR
FT200-SSRL
Multi-Mode Transmitter
FT200-SMT
Multi-Mode Receiver
FT200-SMR
Remark:
If the optical connector is FC type, the suffix in the model number will be “-FXX”. Eg.
FT200-FST
FT200 Series Installation & Operation Manual
www.ot-systems.com 2
Table of Contents
(1) SAFETY INSTRUCTIONS ....................................................................................... 3
(2) PRODUCT OVERVIEW .......................................................................................... 4
2.1 Introduction ....................................................................................................... 4
2.2 Models selection table ...................................................................................... 5
(3) INSTALLATION ....................................................................................................... 6
3.1 General ............................................................................................................. 6
3.2 Standalone unit installation ............................................................................... 6
3.3 Card module installation ................................................................................... 6
(4) CABLE CONNECTIONS & SETUP PROCEDURES ............................................... 7
4.1 System cable connections ................................................................................ 7
4.2 Ground connection ........................................................................................... 9
(5) OPERATIONAL GUIDES ...................................................................................... 10
5.1 FT200 Series Transmitter ............................................................................... 10
5.2 FT200 Series Receiver ................................................................................... 10
(6) SPECIFICATIONS ................................................................................................. 11
(7) DRAWINGS ........................................................................................................... 12
(8) WARRANTY INFORMATION ................................................................................ 12
(9) CONTACT INFORMATION ................................................................................... 12
FT200 Series Installation & Operation Manual
www.ot-systems.com 3
(1) Safety Instructions
Please be familiar with all information in this manual prior to installation and
operation.
Note 1: The products described contain a Class 1 laser or LED fiber optic emitter. The following
safety precautions apply.
Warning: Do not disconnect the fiber optic connector while the unit is powered up.
Exposure to Class I invisible optical radiation is possible when the internal fiber optic
connector is disconnected while the unit is powered up.
Caution: Any access to the controls, adjustments, or performing operations, which are
other than those specified may result in hazardous radiation exposure. Permanent eye
damage or other bodily injuries may be resulted from such exposure even for only
seconds.
Note 2: This assembly contains parts sensitive to damage by electrostatic discharge (ESD). ESD
precautionary procedures should be applied in the course of touching, removing or inserting parts
or assemblies.
Loading...