OT Systems FT100-SSRLSA, FT100-SSTSA, FT100-SMTSA, FT100-SMRSA, FT100-SST Installation And Operation Manual

All Digital Fiber Optic Manufacturing Specialists

Installation and Operation Manual

FT100 Series

10-bit Digital Series

1-ch Video
Fiber Optic Converter

OT Systems Ltd., 2009

Rev 1.1

FT100 Series Installation & Operation Manual

www.ot-systems.com 1

Models covered in this manual

Standalone Units

Single-Mode Transmitters

FT100-SSTSA

FT100-SSTLSA

Single-Mode Receivers

FT100-SSRSA

FT100-SSRLSA

Multi-Mode Transmitter

FT100-SMTSA

Multi-Mode Receiver

FT100-SMRSA

Card Modules

Single-Mode Transmitters

FT100-SST

FT100-SSTL

Single-Mode Receivers

FT100-SSR

FT100-SSRL

Multi-Mode Transmitter

FT100-SMT

Multi-Mode Receiver

FT100-SMR

Remark:

If the optical connector is FC type, the suffix in the model number will be “-FXX”. Eg.

FT100-FST

FT100 Series Installation & Operation Manual

www.ot-systems.com 2

Table of Contents

(1) SAFETY INSTRUCTIONS....................................................................................... 3

(2) PRODUCT OVERVIEW .......................................................................................... 4

2.1 Introduction ....................................................................................................... 4

2.2 Models selection table ...................................................................................... 5

(3) INSTALLATION ....................................................................................................... 6

3.1 General ............................................................................................................. 6

3.2 Standalone unit installation ............................................................................... 6

3.3 Card module installation ................................................................................... 7

(4) CABLE CONNECTIONS & SETUP PROCEDURES ............................................... 7

4.1 System cable connections ................................................................................ 7

4.2 Ground connection ........................................................................................... 9

(5) OPERATIONAL GUIDES ...................................................................................... 10

5.1 FT100 Series Transmitter ............................................................................... 10

5.2 FT100 Series Receiver ................................................................................... 10

(6) SPECIFICATIONS ................................................................................................. 11

(7) DRAWINGS ........................................................................................................... 12

(8) WARRANTY INFORMATION ................................................................................ 12

(9) CONTACT INFORMATION ................................................................................... 12

FT100 Series Installation & Operation Manual

www.ot-systems.com 3

(1) Safety Instructions

Please be familiar with all information in this manual prior to installation and

operation.

Note 1: The products described each contains a Class 1 laser or LED fiber optic emitter. The

following safety precautions apply.

Warning: Do not disconnect the fiber optic connector while the unit is powered up.

Exposure to Class I invisible optical radiation is possible when the internal fiber optic

connector is disconnected while the unit is powered up.

Caution: Any access to the controls, adjustments, or performing operations, which are

other than those facilitated and/or specified may result in hazardous radiation exposure.

Permanent eye damage or other bodily injuries may be resulted from such exposure even

for only seconds.

Note 2: This assembly contains parts sensitive to damage by electrostatic discharge (ESD). ESD

precautionary procedures should be applied in the course of touching, removing or inserting parts

or assemblies.