OT Systems ET1111-B-MT, ET1111-E-MT, ET1111-C-MT, ET1111-D-MT, ET1111-F-MT Installation And Operation Manual

ET1111 Series Installation & Operation Manual

All Digital Fiber Optic Manufacturing Specialists

Installation and Operation Manual

ET1111 Series

Media Converter Series

Industrial 10/100BASE-TX to 100BASE-FX Ethernet Media
Converter

OT Systems Ltd., 2011

Rev 1.0

www.ot-systems.com

Models covered in this manual

Micro Type Wall-Mount

Fiber connector in SC

Multi-Mode (2-Fiber)

ET1111-A-MT

ET1111 Series Installation & Operation Manual

Fiber connector in ST

Multi-Mode (2-Fiber)

ET1111-G-MT

Single-Mode (2-Fiber)

ET1111-B-MT

Multi-Mode (1-Fiber)

ET1111-C-MT

ET1111-D-MT

Single-Mode (1-Fiber)

ET1111-E-MT

ET1111-F-MT

Single-Mode (2-Fiber)

ET1111-H-MT

Multi-Mode (1-Fiber)

ET1111-I-MT

ET1111-J-MT

Single-Mode (1-Fiber)

ET1111-K-MT

ET1111-L-MT

www.ot-systems.com

Table of Contents

ET1111 Series Installation & Operation Manual

TABLE OF CONTENTS ................................................................................................... 1

(1) SAFETY INSTRUCTIONS...................................................................................... 2

(2) PRODUCT OVERVIEW ......................................................................................... 3

2.1 Introduction ...................................................................................................... 3

2.2 Products Highlights .......................................................................................... 3

2.3 Models selection table ..................................................................................... 4

(3) INSTALLATION ...................................................................................................... 5

3.1 General ............................................................................................................ 5

3.2 Package Contents ........................................................................................... 5

3.3 Selecting a site for the Media Converter .......................................................... 6

3.4 Installation ........................................................................................................ 6

3.5 Installation- Wall Mount .................................................................................... 7

3.6 Connecting to Power ....................................................................................... 7

(4) CABLE CONNECTIONS & SETUP PROCEDURES .............................................. 8

4.1 System cable connections ............................................................................... 8

4.2 Connecting to Your Network ............................................................................ 9

(5) OPERATIONAL GUIDES ..................................................................................... 11

5.1 LEDs Status ................................................................................................... 11

5.2 Signal and Power Ports ................................................................................. 11

(6) SPECIFICATIONS ................................................................................................ 12

(7) DRAWINGS .......................................................................................................... 14

(8) WARRANTY INFORMATION ............................................................................... 14

(9) CONTACT INFORMATION .................................................................................. 15

APPENDIX A ..................................................................................................................... I

www.ot-systems.com 1

ET1111 Series Installation & Operation Manual

(1) Safety Instructions

Please be familiar with all information in this manual prior to installation and

operation.

Note 1: The products described contain a Class 1 laser or LED fiber optic emitter. The following

safety precautions apply.

Warning: Do not disconnect the fiber optic connector while the unit is powered up.

Exposure to Class I invisible optical radiation is possible when the internal fiber optic

connector is disconnected while the unit is powered up.

Caution: Any access to the controls, adjustments, or performing operations, which are

other than those specified, may result in hazardous radiation exposure. Permanent eye

damage or other bodily injuries may be resulted from such exposure even for only

seconds.

Note 2: This assembly contains parts sensitive to damage by electrostatic discharge (ESD). ESD

precautionary procedures should be applied in the course of touching, removing or inserting parts

or assemblies.

www.ot-systems.com 2

ET1111 Series Installation & Operation Manual

(2) Product Overview

2.1 Introduction

OT Systems' ET1111 media converter offers an easy and affordable solution for network

managers to connect 10/100 Fast Ethernet from UTP to fiber optic cabling. The media converter

series uses a high performance auto-sensing exchange chip for full functionality of transfer and

exchange, guaranteeing the safety and stability of data transfer. The media converter is available

in both single-mode and multi-mode fiber.

This Sleek Microtype design media converter occupies limited space and it's ideal solution for

easy installation within most camera housings.

2.2 Products Highlights

Basic Features

• Microtype design - fits within most camera housings

• Converts 10/100Base-TX to 100Base-FX

• Full/Half duplex, Auto-Negotiation

• Singlemode or Multimode fiber operation

• Single or Dual-core fiber with SC or ST connectors

• Store and forward switching mechanism

• MDI/MDI-X Auto-Crossover supported

• Plug-and-Play

• 12VDC or 24VAC Terminal Block Power inputs

• -10 °C to 60 °C (14 °F to 140 °F) operating temperature

• Supports Wall Mounting installation.

www.ot-systems.com 3

2.3 Models selection table

ET1111 Series Installation & Operation Manual

Descriptions

Models

Fiber Options Wavelengths

ET1111-A-MT Multimode/2-fiber/SC 1310nm 14dB 2Km

ET1111-B-MT Singlemode/2-fiber/SC 1310nm 21dB 20Km

ET1111-C-MT Multimode/WDM 1-fiber/SC TX:1310nm/RX1550nm 21dB 2Km

ET1111-D-MT Multimode/WDM 1-fiber/SC TX:1550nm/RX1310nm 21dB 2Km

ET1111-E-MT Singlemode/WDM 1-fiber/SC TX:1310nm/RX1550nm 19dB 20Km

ET1111-F-MT Singlemode/WDM 1-fiber/SC TX:1550nm/RX1310nm 19dB 20Km

ET1111-G-MT Multimode/2-fiber/ST 1310nm 14dB 2Km

ET1111-H-MT Singlemode/2-fiber/ST 1310nm 21dB 20Km

ET1111-I-MT Multimode/WDM 1-fiber/ST TX:1310nm/RX1550nm 21dB 2Km

ET1111-J-MT Multimode/WDM 1-fiber/ST TX:1550nm/RX1310nm 21dB 2Km

ET1111-K-MT Singlemode/WDM 1-fiber/ST TX:1310nm/RX1550nm 19dB 20Km

ET1111-L-MT Singlemode/WDM 1-fiber/ST TX:1550nm/RX1310nm 19dB 20Km

Links

Budget

Max.

Distance

Mounting

Micro Type

Wall-mount

www.ot-systems.com 4