ET5200PpH-DR
Hardened IP CCTV Self-Configured 5-port 10/100/1000Base-T with 4-port PoE+ Ethernet Switch
4 V1.1
Power and Alarm Connection:
Pin
Description
V1 - V1 + ALM V2 - V2 +
Power Input
GND
+48~57V
(DC)
Normal
Open
GND
+48~57V
(DC)
Cable Connections
Signal Type Cable Type Connector
Ethernet
Cat. 5 or above RJ45
Power supply 1
Power cable
6-pin Terminal Block(Pin 1/2)
Power supply 2
Power cable
6-pin Terminal Block(Pin 5/6)
ALM
2 wire
6-pin Terminal Block(Pin 3/4)
LED Indicators
Indicator Color Status Description
PW1
Green
ON Powered on
PW2
Green
ON Powered on
ALM
Green ON On when one of the power supplies are off
IGMP
Green
ON Enable IGMP Snooping
OFF Disable IGMP Snooping
PoE Port
(P1-P4)
PoE
Amber
ON PoE is activated.
Blinking A Power Device (PD) is being detected.
OFF No device is connected/ the connected device is not a PD.
LINK/ACT
Green
ON A network device is connected
Blinking The connected device is transmitting/ receiving data.
OFF No network device is connected
G1 Port SPD
Amber
ON Ethernet link at 1000Mbps.
OFF Ethernet link at 10/100Mbps or off link.
Dip Switch
ALM
ON Enable Power Failure Alarm (Default setting)
OFF Disable Power Failure Alarm
IGMP
ON Enable IGMP Snooping (Default setting)
OFF Disable IGMP Snooping
Port
ON Enable Port Failure Alarm
OFF Disable Port Failure Alarm