oticon Opn 1 miniRITE, Opn 1 miniRITE-T, Opn 2 miniRITE, Opn 2 miniRITE-T, Opn 3 miniRITE Instructions For Use Manual
...
Instructions for use
miniRITE
miniRITE T
Oticon Opn™
Oticon Opn S™
Oticon Opn Play™
Oticon Siya
Model overview
This booklet is valid for Oticon Opn™, Oticon Opn S™, Oticon
Opn Play™, and Oticon Siya families, in the following hearing aid
models:
Oticon Opn 1 miniRITE
Oticon Opn 1 miniRITE-T
Oticon Opn 2 miniRITE
Oticon Opn 2 miniRITE-T
Oticon Opn 3 miniRITE
Oticon Opn 3 miniRITE-T
Oticon Opn S 1 miniRITE
Oticon Opn S 1 miniRITE T
Oticon Opn S 2 miniRITE
Oticon Opn S 2 miniRITE T
Oticon Opn S 3 miniRITE
Oticon Opn S 3 miniRITE T
Oticon Opn Play 1 miniRITE
Oticon Opn Play 1 miniRITE T
Oticon Opn Play 2 miniRITE
Oticon Opn Play 2 miniRITE T
Oticon Siya 1 miniRITE
Oticon Siya 1 miniRITE T
Oticon Siya 2 miniRITE
Oticon Siya 2 miniRITE T
LED light (Oticon Opn Play) for visual indication
The LED light is used to help, caregivers, parents, and teachers
to operate the hearing aid and to give instructions on relevant
functions and modes (see relevant information throughout the
booklet).
The following speakers are available for the above models:
Speaker 60
Speaker 85
Speaker 100 (Power Instrument)
Power flex mould speaker 100 (Power Instrument)
Power flex mould speaker 105 (Power Instrument)
Introduction to this booklet
This booklet gives you guidance on how to use and maintain your
new hearing aid. Please read the booklet carefully, including the
Warnings section. This will help you to get the most out of your new
hearing aid.
Your hearing care professional has adjusted the hearing aid to meet
your needs. If you have further questions, please contact your
hearing care professional.
About Start-up Handling Options Tinnitus Warnings More info
For your convenience, this booklet contains a navigation bar to help
you easily navigate through the different sections.
Intended use
The hearing aid is intended to amplify and transmit sound to the
ear, and thereby compensate for impaired hearing within mild to
severe-to-profound hearing loss. This hearing aid is intended for
use by adults and children older than 36 months.
IMPORTANT NOTICE
The hearing aid amplification is uniquely adjusted and optimised
to your personal hearing capabilities during the hearing aid fitting
performed by your hearing care professional.
Table of contents
About
Your hearing aid, speaker, and earpiece 10
miniRITE 12
miniRITE T 13
Identify left and right hearing aid 14
MultiTool for handling of batteries and cleaning 15
Start-up
Turn hearing aid ON and OFF 16
When to replace the battery 17
How to replace the battery (size 312) 18
Put on the hearing aid 20
Handling
Caring for your hearing aid 21
Replace standard earpieces 22
Replace ProWax miniFit filter 25
Continues on next page
Clean customised earpieces 26
Replace ProWax filter 27
Flight mode 28
Options
Optional features and accessories 29
Change volume miniRITE 30
Change volume miniRITE T 31
Change program 32
Mute 34
Use hearing aid with iPhone and iPad 35
Pair with iPhone 36
Wireless accessories and other options 38
Sound and LED indications 40
Table of contents
Tinnitus
Tinnitus SoundSupport™ (optional) 44
Guidelines for tinnitus sound generator users 45
Sound and volume adjustment 46
Limitation on use time 50
Tinnitus SoundSupport warnings 53
Warnings
General warnings 54
More info
Troubleshooting 58
Water & dust resistant (IP68) 60
Conditions of use 61
Warranty 62
Technical information 64
Your individual hearing aid settings 70
10 11
About Start-up Handling Options Tinnitus Warnings More info
About
Your hearing aid, speaker, and earpiece
The standard speakers use one of the following earpieces:
Standard earpieces: Customised earpieces:
LiteTip
VarioTherm® LiteTip
Open dome Micro mould
VarioTherm® micro mould
60 85
Please see details for replacing the dome in
chapter “Replace dome or GripTip”
® VarioTherm is a registered trademark
of Dreve
100 100
105
miniRITE
miniRITE T
Power dome
Grip Tip
Available in small and large, left and
right, with or without vent.
Bass dome, single vent
Bass dome, double vent
* only as open dome for speaker 60
** not for open dome
6 mm5 mm* 8 mm 10 mm 12 mm**
Ear grip
(optional)
Standard
speakers
The hearing aids uses one of the following speakers:
Power flex
mould
speakers
Ear grip
(optional)
Dome sizes
12 13
About Start-up Handling Options Tinnitus Warnings More info
miniRITE
What it is and does
miniRITE T
What it is and does
Push button
Mute, change
volume, and
programs
Microphones
Sound in
Battery drawer
Contains the battery
and functions as an
on/off switch
Battery drawer
Contains the battery
and functions as an
on/off switch
Wax filter
Protects the
speaker from
wax
Wax filter
Wax pro-
tection of
speaker
Speaker
Sound out
Speaker
Sound out
Ear grip
Holds the speaker
in place (optional)
Ear grip
Holds the speaker
in place (optional)
Microphones
Sound in
LED
Program, volume,
battery status
(optional)
Nail grip
Open the
battery drawer
Nail grip
Open the
battery drawer
Push button
Mute, change
volume, and
programs
14 15
About Start-up Handling Options Tinnitus Warnings More info
Identify left and right hearing aid
It is important to distinguish between the left and the right hearing
aid, as they may be programmed differently.
You can find left/right colour indicators in the battery drawer and
on 60 and 85 speakers as shown. Indicators (either L or R) can also
be found on 100 speakers and some earpieces.
A RED indicator marks
the RIGHT hearing aid.
A BLUE indicator marks
the LEFT hearing aid.
MultiTool for handling of batteries and cleaning
The MultiTool contains a magnet that makes it easier to replace the
battery in the hearing aid. It also contains a brush and wire loop for
cleaning and removing earwax. If you need a new MultiTool, please
contact your hearing care professional.
Brush
Wire loopMagnet
IMPORTANT NOTICE
The MultiTool has a built-in magnet. Keep the MultiTool at least 30 cm
away from credit cards and other magnetically sensitive devices.
16 17
About Start-up Handling Options Tinnitus Warnings More info
Turn hearing aid ON and OFF
The battery drawer is used to switch the hearing aid on and off.
To save battery life, make sure your hearing aid is switched off
when you are not wearing it. If you wish to return to the standard
settings of the hearing aid, simply open and close the battery
drawer (quick reset).
When to replace the battery
When it is time to replace the battery, you will hear three beeps
repeated in moderate intervals until the battery runs out.
Three beeps*
= The battery is running low
Four descending tones
= The battery has run out
Battery tip
To make sure the hearing aid is always working, bring spare
batteries with you, or replace the battery before you leave home.
Optional LED
Red blinks, continuously repeated, to indicate battery low.
Turn ON
Close the
battery
drawer with
the battery
in place.
Turn OFF
Open the
battery drawer.
Start-up
* Bluetooth® will be turned off and it will not be possible to use wireless accessories.
Note: Batteries need to be replaced more often if you are streaming to your hearing aid.
18 19
About Start-up Handling Options Tinnitus Warnings More info
How to replace the battery (size 312)
2. Uncover 3. Insert
Fully open the
battery drawer.
Remove the battery.
Remove the sticky
label from the
+ side
of the new battery.
Tip:
Wait 2 minutes so that
the battery can draw
air, to ensure optimal
functioning.
Insert the new battery into the battery
drawer. Make sure the
+ side is facing up.
1. Remove
MultiTool
Close the battery drawer.
The hearing aid will play a
jingle through the earpiece.
Hold the earpiece close to
your ear to hear the jingle.
The MultiTool can be used to
change the battery. Use the
magnetic end to remove and
insert batteries.
The MultiTool is provided by
your hearing care professional.
4. Close Tip
20 21
About Start-up Handling Options Tinnitus Warnings More info
Put on the hearing aid
Ear grip
(optional)
Place the hearing
aid behind your ear.
The speaker should
always be used
with an earpiece
attached. Use only
parts designed for
your hearing aid.
Hold the bend of
the speaker wire
between your
thumb and index
finger. The earpiece should point
towards opening of
the ear canal.
Gently push the
earpiece into your ear
canal until the
speaker wire sits
close to your head.
If the speaker has an
ear grip, place it in the
ear so it follows the
contour of the ear.
Step 1 Step 2 Step 3
Handling
Caring for your hearing aid
When handling your hearing aid, hold
it over a soft surface to avoid damage
if you drop it.
Clean the microphone openings
Carefully brush any debris away
from the openings. Gently brush the
surface. Make sure the brush is clean
and that it is not pressed into the
openings.
IMPORTANT NOTICE
Use a soft, dry cloth to clean the hearing aid. The hearing aid must
never be washed or immersed in water or other liquids.
Microphone
openings
22 23
About Start-up Handling Options Tinnitus Warnings More info
IMPORTANT NOTICE
If the earpiece is not on the speaker when removed from the ear,
the earpiece may still be in the ear canal. Consult your hearing care
professional for further instructions.
Replace standard earpieces
The standard earpiece (dome or Grip Tip) should not be cleaned. If
the earpiece is filled with wax, replace it with a new one. Grip Tip
should be replaced at least once a month.
Hold on to the
speaker and then
pull off the earpiece.
Insert the speaker
exactly into the
middle of the
earpiece to obtain a
secure attachment.
Push firmly to ensure
that the earpiece is
fastened securely.
Step 1 Step 2 Step 3
Loading...