OTF Distribution OT-BURN-1 User Manual

burn

Quick Start Guide

Instructions for:

1. Getting Started

2. Downloading the Orangetheory App

3. Charging Device

4. Proper Placement

5. Pairing Device

6. LED Guide

7. Caring for Device

8. Technical Specifications

Getting Started:

1. Included in packaging: OTbeat Burn, SM band, LG band, & USB cord

2. Remove OTbeat Burn from packaging

3. Connect USB cord into charging port of device

4. LED light will appear after a few seconds

Downloading the Orangetheory App:

*Using your mobile device, download the Orangetheory App.

OTbeat Burn Quick Start Guide

Orangetheory App

Note: Fully charge device before attempting to pair for the first time.

Page 2

Charging Device:

1. Open rubber port cover on back of device

2. Plug in mini-USB connector into device port

3. Plug in regular USB connector into charging block

4. Plug in charging block into wall outlet

(BACK OF OTBEAT BURN)

Optical heart rate sensor
LED lights

OTbeat Burn - Charging Device

Device can be connected directly to a computer USB port.

Note: The voltage differs from wall outlet to computer.

Battery is fully charged when Green LED is continuously on
During charging: Red LED light will blink slowly
LED indication for charging is in front of device

Page 3

Proper Placement:

To transmit accurate data from your device:

1. Fasten device snugly in one of the below placement options

2. Wear device below, and not directly on top, of wrist bone* or elbow

3. The optical sensor on the back should make good contact with skin

*For placement on wrist, measure two fingers above wrist bone

--------------------

Elbow

--------------------

-------------------­Wrist bone

OTbeat Burn - Proper Placement

--------------------

Page 4